mattbta
Latest activity Postings About
-
-
mattbta reacted to Aquamania001's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with
Like.
Had the heater assembly lines replaced. Went from the water pump to the heater core. Noticed a slow leak from watching my expansion... -
mattbta reacted to Tozan's post in the thread Slight miss at idle, poor MPG, sooty exhaust pipe, No codes. 250K with Like.
So far I cleaned the MAF replaced the air filter and replaced the up stream O2 sensor. I just did a hunting trip this past week so...
-
mattbta replied to the thread Electric Fan Conversion Question.15780789 is the older 7/9 bladr K5L 700w assembly. Got mine on eBay. Seemed to work better than the newer 5/5 blade 700w for me in...
-
mattbta reacted to Fless's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
If you look up the arms for a 2000-2002 Tahoe, Yukon, Suburban they should be the right ones. Rock Auto shows only the right...
-
Update on the brake noise. Only happens at low speed when coming to a stop . It turned out it was the wheel speed sensor. Easy fixed .
-
mattbta replied to the thread Reman engine no start than start with detonation..Like this?
-
My '04 L59 with 114K on the clock runs about the same at hot idle. I recently had the oil pan gasket replaced and had them change the...
-
That seems about what the 5.3 on my truck idles to.
-
mattbta reacted to strutaeng's post in the thread strutaeng's 04 2500 4x4 project Suburban with Like.
Ok, I finally was able to paint the hood. Didn't come out too bad in my opinion. IDK
-
My understanding is that the way Amazon works is… when you buy an item, it may have 10 different suppliers for the same item… all 10...
-
mattbta reacted to Scottydoggs's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Haha.
usally the pedal is rock hard when the booster is bad. like when the truck is off, a few pumps and its rock hard. <<<<man that didnt...
-
mattbta reacted to latvius's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Love.
Did you replace the centerlink?
-
mattbta reacted to viven44's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Finally fixed the mode door actuator and also took care of the DTC B3761. It has some idiosyncrasies in how it wants to be programmed… I...
-
mattbta reacted to latvius's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Rewrapped that big bundle of engine wires. Got rid of this crumbling mess Installed a nice new wrap and since I have never seen a T...
-
-
Loading…
-
Loading…
Forum statistics
Latest posts
-
-
-
-
Looking to Come Back to the Family - 2022 Yukon XL - High Miles- Latest: justchecking