Forums
New posts
Search forums
What's new
New posts
New resources
Latest activity
Resources
Latest reviews
Search resources
Log in
Register
What's new
Search
Search
Search titles only
By:
Latest activity
Register
Menu
Log in
Register
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
J
jfoj
Full Access Member
Joined
Aug 9, 2012
Last seen
13 minutes ago
·
Viewing thread
Lifter Failure Root Cause Same as HEMI?
Posts
357
Reaction score
264
Points
63
Find
Find content
Find all content by jfoj
Find all threads by jfoj
Latest activity
Postings
About
J
jfoj
replied to the thread
Lifter Failure Root Cause Same as HEMI?
.
From my experience the Range device works well but seems to still activate the DFM lifters during Decel With Fuel Cutoff (DFCO). I have...
Yesterday at 6:25 PM
J
jfoj
replied to the thread
Need vehicle opinion other than my wifes
.
Give this man above the prize!!!! In my household it always seems to be "Reassign the blame"!!!! If the wife gets what she wants, then...
Friday at 11:46 AM
J
jfoj
replied to the thread
Yukon Stopped While Driving
.
The history shows either the high Amp fuse (400 Amp) for the starter and/or the fuse block needs to be replaced when the engine cranking...
Friday at 11:31 AM
J
jfoj
replied to the thread
Is New Engine Break In Procedure Still Necessary?
.
@Silverado4x4 Believe what you want. DI engines are a much different animal than previous port injected engines. The higher pressure...
Friday at 9:04 AM
J
jfoj
replied to the thread
What is the quarts "range" on the dipstick on these trucks?
.
@blanchard7684 Oil temps were at 226F for approximately So oil temps were 220F or higher for 1 hour and 40 minutes of my drive. Total...
Friday at 8:43 AM
J
jfoj
replied to the thread
Is New Engine Break In Procedure Still Necessary?
.
Back to the original question about break in oil, from initial oil analysis it appears that the factory fill has a higher level of Moly...
Friday at 8:22 AM
J
jfoj
replied to the thread
Is New Engine Break In Procedure Still Necessary?
.
@Fairweatherider Fuel contamination can be managed, however, it can also become cumulative depending on the weather and driving...
Friday at 8:04 AM
J
jfoj
replied to the thread
What is the quarts "range" on the dipstick on these trucks?
.
Thanks for the reply. I am just trying to get a feel for folks that are seeing oil consumption to understand how much is oil...
Thursday at 4:11 PM
J
jfoj
replied to the thread
Yukon Stopped While Driving
.
@Pattipartyof5 If you have a 6.2l, I would be getting worried. Sounds like a precursor to bearing problems. I would be checking the...
Thursday at 1:54 PM
J
jfoj
replied to the thread
What is the quarts "range" on the dipstick on these trucks?
.
Yes and no. 8 quart fill with filter only puts the oil level about 1/3 up the dipstick. Are you running 0W20 oil? How many miles on...
Thursday at 1:49 PM
J
jfoj
replied to the thread
Is New Engine Break In Procedure Still Necessary?
.
Best thing you can do is do not take short 15 minute trips, depending on the outside ambient temp the engine oil in these engines can...
Thursday at 1:06 PM
J
jfoj
replied to the thread
New 2024 Yukon XL Denali
.
Engine build date tag is on the rear of the drivers side cylinder head, can be seen from under the car, ramps will be what you need or...
Tuesday at 9:54 AM
J
jfoj
replied to the thread
New 2024 Yukon XL Denali
.
Nothing will come of the NHTSA investigation for a while. See this - Thread Post
Tuesday at 9:43 AM
J
jfoj
replied to the thread
NHTSA opens preliminary probe into more than 870,000 GM vehicles
.
Article from The Car Connection Seems to indicate that at least 346 reports have been filed with NHTSA. Assume this is less than 20% of...
Tuesday at 9:39 AM
J
jfoj
replied to the thread
New 2024 Yukon XL Denali
.
I get it about being paranoid. I am not happy about having to not just being blissfully ignorant when driving modern vehicles, but these...
Tuesday at 9:04 AM
Loading…
Loading…
Forum statistics
Threads
133,912
Posts
1,893,300
Members
99,315
Latest member
relx
Latest posts
What part is this?
Latest: mikez71
Today at 2:03 AM
General Discussion
Aluminum / XFE NNBS Front Suspension Rebuild
Latest: mikez71
Today at 1:23 AM
Street Suspension
T
Issues with Mobile Service +
Latest: tyet
Today at 1:07 AM
General Discussion
T
Black Exhaust Tips for RST Performance Edition?
Latest: The Widge
Today at 12:32 AM
Exterior
Exhaust Manifold Gaskets/Lifter Tick
Latest: JPVortex
Today at 12:27 AM
Engine & Drivetrain
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top