-
-
Ever notice how the rear glass gets dirty? There is a vacuum back there when driving and it will bring the exhaust fumes into the cabin... -
PatDTN replied to the thread How often do you go WOT aka "Italian tune up"?.For me it's a self control issue. Since I swapped in the cammed and tuned 6.2 I love seeing the traction control light up at 30 mph or so.
-
PatDTN replied to the thread Drive with lift glass open?.These vehicles mostly have a tow hitch. Lowes and Home Depot have trailers. Around the places I've been some pl especially even have a...
-
PatDTN replied to the thread IS AFM DISABLEMENT NECESSARY??.If these things were a constant problem GM's beancounters wouldn't let GM continue adding an expensive piece of equipment when they'll...
-
PatDTN replied to the thread IS AFM DISABLEMENT NECESSARY??.Here's my opinion (all of these responses are opinions.) I had a problem with my stock 5.3 when it suddenly started guzzling oil and got...
-
PatDTN replied to the thread 09 tahoe ltz hood open, stabilitrack, traction control, et al.I left the sensor on the new ground wire. If I detect a problem that might be caused by it I can disconnect it and connect the one that...
-
PatDTN reacted to Big Mama's post in the thread 09 tahoe ltz hood open, stabilitrack, traction control, et al with
Like.
Nice! There are so many things that go wrong where you’d never expect to find the problem was a bad cable. Good to know it’s fixed. -
PatDTN replied to the thread 09 tahoe ltz hood open, stabilitrack, traction control, et al.Despite the fact that the ground cable resembling an octopus with too numerous connections it cured the stream of error messages. I...
-
PatDTN replied to the thread 09 tahoe ltz hood open, stabilitrack, traction control, et al.Yesterday I read about bad battery cables causing a host of issues just like mine. I opened the hood and started tugging on the battery...
-
-
PatDTN replied to the thread 2013 Tahoe Gear Shift Lever loose and will not go into gear..I did pull the lever, ground off the rivet and punched it out. Tried to tap it to 1/4-20 but didn't get the tap to bite. I drilled it to...
-
PatDTN replied to the thread 2013 Tahoe Gear Shift Lever loose and will not go into gear..I'm finally back to working on this after being out of town for a couple weeks and then having the Tahoe in the body shop to repair...
-
I just did this project. At the same time, I also replaced the transmission mounts and I replaced the front sway bar bushings and...
-
-
Loading…
-
Loading…
