-
-
Scottydoggs replied to the thread Swapping rear axles between 1500 HD and 1500.dont think you can swap the axels. the 8 lug is likely a full floating rear end. in layman terms, the tahoe 10 bolt axel rides on a... -
Had the dreaded hinge break on my back hatch glass a while back. Haven't been able to use it. Been going to replace it but never got...
-
Scottydoggs reacted to Fless's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with
Like.
Disconnected the trickle charger so it's ready to drive to the orifice tomorrow. I'm finally out of the "boot" that was needed after... -
Scottydoggs replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.rear center is what your looking for. ac delco is like 10 bucks more listed at the bottom...
-
Scottydoggs reacted to ScottyBoy's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
I am ashamed to admit, I am in the same boat. My rear passenger side regulator started acting up almost a year ago. It had trouble going...
-
Scottydoggs replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.same deal here. if it was the d/s back it would have been fixed long ago. mine was shut for so long it was glued up in the frame, the...
-
Scottydoggs replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.ive had pass rear dead window regulator or motor for ohhhh, say 3 years now lol i bought 4 new regulators 5 years ago on close out at...
-
Scottydoggs reacted to Tonyrodz's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Wow.
This hose was a week old. It wasn't leaking, it was actually squirting out whenever the pedal was stepped on.
-
Scottydoggs replied to the thread Rear heat system.iirc them lines run in the rocker panels, ac lines and heater lines.
-
Scottydoggs replied to the thread Steering not returning to center?.the box would be suspect for sure. were the idler and pitman arm worn out already, or the trash that stole it put a beating on it and...
-
Get some vacuum tubing and reconnect them.
-
Scottydoggs reacted to ncalvo's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Polished and waxed the truck yesterday, also i am a big fan of the cerakote trim wipes, they work very well and I only use half the box...
-
Scottydoggs reacted to latvius's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
yes did not remove it
-
Scottydoggs replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.your still using the pcv valve right? with out that regulating the flow you might hear it sucking the air through then.
-
Scottydoggs replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.if you can hear the vacuum through the hose buy better hoses. i got that cheap ass can off amazon and the hose that comes with it is so...
-
-
-
Loading…
-
Loading…
