Charlie207's latest activity
-
Yup, I had a project like that once. The secret to getting started again is to dedicate 30-60 minutes every other day for a couple of... -
Charlie207 reacted to Geotrash's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with
Like.
Agreed on the underlying issues. In my case, the dead battery was my own fault - I'd left a Range AFM disabler plugged into the OBD... -
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.I would love to run a block heater, but there is no easy or practical way to power one. Looking at the most logical reasons for a...
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.I think as long as you have a good battery, and you remove any electrical issues, you'll be fine. It's been incredibly cold here, well...
-
-
Charlie207 replied to the thread Power dyne bd-11a question.Don't forget to add ring-gap.
-
Charlie207 replied to the thread Black Bear Performance review after several months - engine, trans, AFM/DOD.I just think this highlights one of the important shortcomings of "email tunes". There is basically no one nearby that can do a road...
-
Charlie207 replied to the thread Black Bear Performance review after several months - engine, trans, AFM/DOD.I assure you that's not the case.
-
Charlie207 replied to the thread Black Bear Performance review after several months - engine, trans, AFM/DOD.I have their ECU/TCM tune in my 6.0, and had the same package when there was a 5.3 in it. The problem arises when I touch the gas...
-
Charlie207 replied to the thread Eric O-Exhaust Manifold Bolt Removal.The grease that binds the metallic (or non-metallic) anti-friction components resists higher temps, and won't liquefy or flash off.
-
Charlie207 replied to the thread hum or howl in 4wd.That stinks, but eBay is your friend.
-
Charlie207 replied to the thread Eric O-Exhaust Manifold Bolt Removal.The two broken bolts in my 2014 5.3 came out with just vice grips. I thought they were going to be rusted in place, but it was probably...
-
Charlie207 replied to the thread hum or howl in 4wd.They should run silent or near-silent in 2WD. Did you drain the front diff fluid to look for sparkles? You don't even need to drain...
-
Charlie207 reacted to OR VietVet's post in the thread 1977 454 ci. complete big block .030-SOLD with Like.
After talking to the buyer and telling him the specs on the crankshaft, .010 on the mains and .020 on the rods and that there is 2 sets...
-
Charlie207 replied to the thread DIY Mid & Long LCA's / UCA's.....and everything else you'll need to have and know.So... what about the front control arms?
-
Charlie207 reacted to 89Suburban's post in the thread 2008 Tahoe power steering fluid change with Like.
I recommend investing in one of these for DYI fluid exchanges...
