donjetman's latest activity
-
Buy the replacement transmission then remove the pan then control body assembly (TEHCM, valve body, IMS, speed sensors/harness). Next... -
donjetman replied to the thread Oil Cooler Adapter w/Thermostat.If you tow (oil, H2O, ATF gets too hot) and your Yuk didn't come with an oil cooler, this can be part of a oil cooler system install...
-
donjetman replied to the thread 07 fuel pump and gas gauge.Earlier this yr I installed a new Bosch # 67442 Fuel pump module in our 07 Denali w/195k miles. It was running great but the fuel gauge...
-
donjetman reacted to NickTransmissions's post in the thread 2010 Suburban with Transmission problems with
Like.
All those TCM codes indicate temp sensor & pressure switch failures - the trans temp sensor and pressure switches are integrated into... -
donjetman reacted to NickTransmissions's post in the thread GM 6L80 Transmission Information Thread with Like.
First thing I'd do if I were you is a line pressure test...Wear in the PR valve should show up there...Refer to the first page and post...
-
donjetman replied to the thread just randomly dies.intermittent fuel starvation (pump) ??
-
they also make one wo/thermostat, and a lot of other cool stuff...
-
Man, that's a lot of places for failures!
-
The e-brake area and a few others are in a service bulletin.. (with photos) https://static.nhtsa.gov/odi/tsbs/2012/SB-10043829-6448.pdf
-
donjetman replied to the thread SOLVED: Fuel pump install issues.I didn't have a hard time installing the new Bosch # 67442 Fuel pump module in our 07 Denali a few months ago?
-
donjetman replied to the thread poltergeist in the electrical system.download to youtube and provide us the link here.
-
Not the o-ring, the pump just didn't fit the hole and I had to use a lot of force (hitting with rubber mallet) to get it to go in. The...
-
donjetman reacted to NickTransmissions's post in the thread Tranny rebuild Tri-State area with Like.
Gary Ferarro, AAA-1 Transmissions - (516) 486-1012 (Hempstead, NY) Chris Kerkonis, CK Performance - (347) 836-8142 (Bayside, NY)
-
If your vent valve and lines are working correctly, and the engine is off and the key out of the ignition, there shouldn't be any...
-
donjetman reacted to SpareParts's post in the thread OK, Bought a 07 with a couple problems today. with Like.
Also found a great parts cleaner. Gets old varnish and gunk off pretty good. I tossed the parts in a bucket and let them soak for a...
