Eman85's latest activity
-
EEman85 replied to the thread Exhaust flange above X member....I just replaced the flange gasket on a Tahoe. I have a torch so that helped with the 2 outer ones. The inner one was so bad it just...
-
EEman85 replied to the thread 1999 Tahoe, soft brake pedal.https://www.amazon.com/Master-Cylinder-Plugs-Compatible-Inverted/dp/B0CCXMT9JZ/ref=pd_ci_mcx_pspc_dp_d_2_t_1?pd_rd_w=y2Ijy&content-id=amz...
-
EEman85 replied to the thread 1999 Tahoe, soft brake pedal.There is no such thing as an odd strange thread, it's all measurable and once you know the size you just buy a plug that size, I don't...
-
EEman85 replied to the thread 2dr vs 4dr cargo area.I know there is one in my daughter's 2 door, don't know the brand it was in there when we bought it. If I get a chance I'll look and see...
-
EEman85 replied to the thread 1999 Tahoe, soft brake pedal.Best fix I found on OBS trucks is to use a NBS MC, makes the pedal feel like you're actually going to stop. I must just be lucky but...
-
EEman85 replied to the thread Code p03041 cam position sensor.Did you check distributor offset with a scan tool?
-
EEman85 replied to the thread Rear Tail Light And Brake Light Out.On these trucks the low beams are made to go off when the high beams are on if it's never been modified. Does the high beam indicator on...
-
EEman85 replied to the thread Rear Tail Light And Brake Light Out.I'm guessing you have a 91-99 Tahoe. I would use a test light or voltmeter and check for both power and ground at the taillight and...
-
EEman85 replied to the thread when to replace front wheel bearings on a 4x4.Replace them and you'll be replacing them often, the junk you buy won't last as long as the factory ones. Leave the sleeping dog alone.
-
EEman85 replied to the thread Rear Seat Won't Lay Flat.I remember having the same problem on my daughters 2 door. Did you move the front seats forward and remove the headrests?
-
EEman85 replied to the thread 1999 Tahoe brake lights staying on - SOLVED.I'll do 2 door hinge pins over 1 brake light switch any day.
-
EEman85 replied to the thread AC compressor.I open high and low engine off then shut the valves when freon stops flowing. Then start engine and with it running and AC on I charge...
-
EEman85 replied to the thread AC compressor.Last 2 I did I just bought a complete kit with accumulator, orifice and all of the rest. Total freon charge amount should be on a...
-
EEman85 replied to the thread SOLVED!!! '96 Yukon Cylinder 5 Misfire.Timing "gun" or timing light isn't used on a Vortec engine, need a scan tool that can tell you the readding. A flashing spark tester...
-
EEman85 replied to the thread Dual battery set up.Are you wanting a dual battery for starting power? Power a camper? An isolator will allow the extra battery to charge and not discharge...
