ivin74's latest activity
-
ivin74 reacted to latvius's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with
Like.
Controls the speed of the blower fan, usually you can tell it is bad when all your mid range settings don't work and you only have full... -
@Matthew Jeschke , A few little tidbits. The vette manifolds flow marginally better. But, the truck manifolds don't start becoming a...
-
ivin74 reacted to Trey Hardy's post in the thread No forward gears, but revers works after loud clunk at nearly WOT. with Wow.
That sucks man I thought performabuilt were some good transmissions too I still haven’t tackled pulling mine yet I’ve been dreading it...
-
ivin74 reacted to Tonyrodz's post in the thread No forward gears, but revers works after loud clunk at nearly WOT. with Like.
I sure don't envy you Sam. Pulling and reinstalling a trans isn't easy. Hopefully you have some help lined up.
-
ivin74 reacted to NickTransmissions's post in the thread No forward gears, but revers works after loud clunk at nearly WOT. with Like.
You're welcome, Sam... I do the same for my customers if they have a fluke failure like yours after overhaul...I only do bench jobs so...
-
ivin74 reacted to ScottyBoy's post in the thread No forward gears, but revers works after loud clunk at nearly WOT. with Like.
Sounds like the transmission is toast. When mine failed, it went out in a similar fashion. I could only drive in Reverse, or in 1st...
-
ivin74 reacted to Sam Harris's post in the thread No forward gears, but revers works after loud clunk at nearly WOT. with Like.
Thank you for the info. I was getting a small amount of “clunk” when dropping all the way down into 1st, but still no movement. Now, I...
-
ivin74 reacted to NickTransmissions's post in the thread No forward gears, but revers works after loud clunk at nearly WOT. with Like.
Forward sprag or low roller one-way clutch. If you have no forward movement in manual low then low roller has failed (these dont go bad...
-
ivin74 reacted to Dave Jr's post in the thread 3rd row seat removal Premier Edit:deck added with Like.
Tuck the plug for the motor control under the trim panel I used a hot glue gun to secure the spacers. Double sided tape works too. I...
-
Parts are arriving in a few days. I will make a new post with pics & part numbers. Everything in new except the rear calipers which I...
-
ivin74 reacted to buckwild27's post in the thread 4 Piston Big Brake Upgrade from 2019-20 with Like.
Take lots of pictures and post them when you swap it over.
-
ivin74 reacted to makintoshnex's post in the thread Looking to buy a work truck. Need expert assistance. with Like.
Yea that caddy is all time 4 wd. The only thing is that pA truck is in way better condition than NYC Tahoe, and I can't find anything...
-
ivin74 reacted to romakdaddy's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
It wasn't exactly today...more like the last few months but here goes. BEFORE: AFTER:
-
ivin74 replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.What does the resistor do?
-
Dang man that’s some rough shenanigans. Hopefully feeling better happens sooner rather than after for you! Congrats on the kid...
Forum statistics
Latest posts
-
-
-
-
Show off your 2015+ leveled Tahoes and Yukons!
- Latest: CarolinaCoastal18