Matthew Jeschke's latest activity
-
Sounds like you may have blown up your rear end. Drain it and see what comes out. Or just pull the diff cover and see what is going on. -
Matthew Jeschke replied to the thread Electric Fan Conversion Question.Where did you source your fans from? I'm looking at RockAuto and they don't seem to have a OEM fan assembly. My plan is to buy part from...
-
-
Matthew Jeschke reacted to Rocket Man's post in the thread Electric Fan Conversion Question with
Like.
Do not buy an aftermarket harness unless you enjoy melted wires on a hot day. Fix up that factory harness. -
Matthew Jeschke replied to the thread Need help troubleshooting.Fluid pic looks good. That's reassuring. Not to say there's nothing in bottom of pan, but at least you aren't seeing clutch material in...
-
I'd take the driveshaft off. See if the tires will spin then. If they still don't then pop the rear end cover off and see what's...
-
The broken part in the pic is not at all related to why your vehicle won't move. The sway bar link is for nothing more than vehicle...
-
Matthew Jeschke replied to the thread Need help troubleshooting.What I understand... Engine revs, truck doesn't move. Need a few more details. I know you lifted up the rear end but not for sure...
-
First pic is passenger second driver. It’s a 2006 2wd. will check all the fluids when it’s Not so gloomy out. Put it in every gear but...
-
Matthew Jeschke replied to the thread Need help troubleshooting.I'm not familiar with the 2wd frame / suspension. However, that's a sway bar end link. You'll want to order a new one. Not sure if it's...
-
Matthew Jeschke replied to the thread Tire Noise Reduction -- Any Experiences with Fender Liner and/or Fenderwell Treatments?.Not sure if I'd want to use Dynamat or similar style insulation on areas outside the cabin. I think that stuff is designed for use...
-
Matthew Jeschke replied to the thread Need help troubleshooting.I'm unsure what that is from your picture... Can you get a better of the broken linkage. That doesn't look familar to me. What's it...
-
Matthew Jeschke replied to the thread Bleeping QD lines to evap / fuel system.How long would you say would be a "pass" for holding pressure? 15 minutes or something?
-
Matthew Jeschke reacted to Fless's post in the thread Bleeping QD lines to evap / fuel system with Like.
I haven't seen any adapters for the purge line; I think something like a somewhat pointed rubber-tipped air hose connection might work...
-
Has that low mileage been verified? That can also happen when a cluster has previously been rebuilt and the needles weren't put back in...
-
Thank you! And yes it was doing the same thing before I did the stepper motors.
