rdezs's latest activity
-
Rrdezs reacted to solli5pack's post in the thread Front Crank Seal Popping Out After AFM Delete with
Like.
You do need an alingment tool. Especially if the oil pan was removed. This is what I used when I did the AFM delete on my Burb. -
Rrdezs replied to the thread 2011 Tahoe/Real axle bearings Timken versus stock.I'll have to take some pictures for you. You might want to look up the RPO code for the upper picture. That axle flange is a lot closer...
-
Rrdezs replied to the thread 2011 Tahoe/Real axle bearings Timken versus stock.
-
-
Rrdezs replied to the thread 2011 Tahoe/Real axle bearings Timken versus stock.
-
-
Rrdezs replied to the thread 2011 Tahoe/Real axle bearings Timken versus stock.Are you sure the bearings are the same? I would double check, as there's a couple different flavors of the 9.5 semi-floating axle with...
-
Rrdezs replied to the thread 2011 Tahoe/Real axle bearings Timken versus stock.My 2014 all wheel drive Escalade has the 9.5 inch 14 bolt rear differential. The 8.5 in uses different bearings and seals. You might...
-
-
Rrdezs replied to the thread DOD delete but keep VVT?.You can plug the oil pressure relief in the pan when deleting the AFM. It's there to protect the AFM solenoids in case your pressure...
-
Rrdezs replied to the thread DOD delete but keep VVT?.You should have higher pressure off the pump.... But if that relief valve that's inside the pan is bad, it will dump your oil pressure...
-
Rrdezs replied to the thread DOD delete but keep VVT?.From reading what you posted, it sounds like you reused the o-ring? I hope not.... If you did, pull the pan and replace it. Look online...
-
Rrdezs replied to the thread 2011 Yukon Transmission issues..... A little bit of maintenance does wonders
-
Rrdezs replied to the thread Intermittent oil pressure loss.Sounds very typical of the oil pressure relief valve in the oil pan getting weak, or the pressure relief valve in the oil pump.
-
Rrdezs replied to the thread Rattling Sound From Rear and Highway Vibration.I recently did the u-joints in my wife's 2014 Escalade when it had around 162,000 miles, just as a preventative maintenance thing. Each...
-
Rrdezs replied to the thread Need help with rear pinion flange.For years, I've used a little RTV on the splines to prevent gear oil from working up the splines. Actually what Borg Warner shop manuals...
-
Rrdezs replied to the thread 2012 Yukon XL - 6.2L Engine Rebuild/Swap & Addressing AFM/DOD."Serious power" by definition will very with each person and what they want. Would I refer to in that respect when talking about a Tahoe...
-
Rrdezs replied to the thread 2011 Yukon Transmission issues.Have you tried changing the filter? And saying what's in the bottom of the pan? I would start there. Sounds like a fluid starvation...
