rockola1971's latest activity
-
rockola1971 replied to the thread Dragging brakes 2004 Yukon - SOLVED.The Tech II auto bleed is made for dummies. It starts off by telling you to press brake pedal while in neutral/park. Then it tells you... -
Doesn't the Tech 2 prompt you for procedure when you select the ABS bleed?
-
rockola1971 replied to the thread 2004 Yukon XL 4x4 Transfer Case Issues.Yup encoder motor commutator ring(mounted on encoder motor) is dirty/worn and the 4wd system is lost and doesnt know what position the...
-
NP8 is the 2-speed transfer case (NVG246) that takes Auto-Trak II fluid (it's blue). Verify that the fluid level is good. If you drain...
-
rockola1971 replied to the thread Completely Dead - Help - SOLVED.Jump the large terminals of the solenoid and if it spins the starter over just fine then you have a ignition control side problem. If...
-
rockola1971 replied to the thread Completely Dead - Help - SOLVED.Did you check the engine block ground wire? The symptoms you are having copy a dirty/corroded/loose/broken battery wire. Check the...
-
rockola1971 replied to the thread No spark on 03 yukon.Check your fuses. Especially ones marked PCM and IGN.
-
Check the seller on Amazon even if it says it's an ac delco. A lot of fakes out there. Personally I would only buy online from rockauto...
-
rockola1971 replied to the thread New throttle body - Limp Mode.When you say its "going into limp mode", what do you actually mean? Check engine light flashing? Or is it on steadily? Does the...
-
You may want to see what OBD code(s) are in the system. Put a good bi-directional scanner on it and when it goes into limp mode write...
-
rockola1971 replied to the thread Vibration at highway speeds....did I put my driveshaft back up wrong?.If your driveshafts are original to the 2003 vehicle AND the Original ujoints are still installed then your Ujoints need replaced! No...
-
rockola1971 replied to the thread P2671 Actuator Supply Voltage B Circuit High.You have a broken wire between your TCM and solenoid(s) within your transmission. The broken wire can either be internal to the tranny...
-
rockola1971 replied to the thread Vibration at highway speeds....did I put my driveshaft back up wrong?.Can you tell if the vibration is coming from the front or rear of the vehicle?
-
rockola1971 reacted to Doubeleive's post in the thread Vibration at highway speeds....did I put my driveshaft back up wrong? with
Like.
you can try disconnecting the shaft and flip it 180deg, then bolt it back up. that's about all you can do "easily" to see if it makes... -
rockola1971 reacted to Scottydoggs's post in the thread Vibration at highway speeds....did I put my driveshaft back up wrong? with Like.
now the front shaft does have a slipper shaft in it, that one needs to be clocked so they are in the same direction on both sides of the...
