Forums
New posts
Search forums
What's new
New posts
New resources
Latest activity
Resources
Latest reviews
Search resources
Log in
Register
What's new
Search
Search
Search titles only
By:
Latest activity
Register
Menu
Log in
Register
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
rockola1971
Full Access Member
·
From
Indiana (formerly IL)
Joined
Dec 29, 2016
Last seen
Yesterday at 8:15 PM
Posts
2,405
Reaction score
3,041
Points
113
Find
Find content
Find all content by rockola1971
Find all threads by rockola1971
Latest activity
Postings
About
rockola1971
replied to the thread
Transmission Issues P0758!
.
B solenoid or its associated wiring or sticking associated valve(worn valve/valve body bore or dirty fluid causing valve(s) to hang up...
Yesterday at 8:15 PM
rockola1971
replied to the thread
Stuck in 4WD. Any help?
.
Was the sound coming from your encoder motor or Tcase? Installation of encoder motor is hook wiring harness to it while it is OFF of...
Yesterday at 8:11 PM
rockola1971
replied to the thread
02 Tahoe P0300 code
.
Need to get a fuel pressure reading at the rail at idle and part throttle and before engine crank but key on. Whats your readings...
Tuesday at 7:43 PM
rockola1971
replied to the thread
01 Shutting off no crank, no start.
.
Is the security light flashing or remaining on after the vehicle starts? Security should not keep the engine from cranking or starting...
Tuesday at 7:39 PM
rockola1971
reacted to
Kgitti's post
in the thread
2002 Yukon fuel pump toast? Fixed
with
Wow
.
So it was the fuel pump. I went the hatch method cutting beyond the spot (drilled them out) welds, a harder way to go but safer in the...
Sunday at 7:38 PM
rockola1971
reacted to
Kgitti's post
in the thread
2002 Yukon fuel pump toast? Fixed
with
Haha
.
I’m right there. ACDelco on order. Hatch cut and ready. A bit of a PITA as I chose to cut it outside the spot welds thinking the...
Sunday at 7:37 PM
rockola1971
reacted to
Fless's post
in the thread
2002 Yukon fuel pump toast? Fixed
with
Like
.
Not judging, but personally I would have someone else (friend or shop) drop the tank so I could avoid doing the a "hatch & patch." But...
Sunday at 7:36 PM
rockola1971
replied to the thread
04 Z71 Should I tune it?
.
HP/Torque Boost and better MPG dont usually happen at the same time. You get to choose one way or the other. The K chassis is not a...
Sunday at 1:17 PM
rockola1971
replied to the thread
Where should I start?
.
Make sure original codes have been cleared from PCM and then see what comes back. Verify with a scanner that O2 sensors are switching...
Sunday at 12:57 AM
rockola1971
reacted to
Marky Dissod's post
in the thread
Where should I start?
with
Like
.
Next part to throw at it is the flex fuel composition concentration sensor. When this thing goes bad / gets old, as a precaution, it...
Sunday at 12:50 AM
rockola1971
replied to the thread
04 Z71 Should I tune it?
.
290k? What you need first is a new or reman long block if you plan on running your engine hard. Not saying current engine wont last...
Sunday at 12:49 AM
rockola1971
replied to the thread
Stuck in 4WD. Any help?
.
C0324 is your tattletale. This code means your lock solenoid in your encoder motor is short to ground. This solenoid is ground seeking...
Saturday at 9:07 PM
rockola1971
replied to the thread
Help! 02 Tahoe no crank no start after engine warms up past 160 degrees
.
No crank, no start is not likely a PCM issue unless there is green/blue crustys growing on the terminal connnectors at the PCM...
May 10, 2024
rockola1971
reacted to
Doubeleive's post
in the thread
Help! 02 Tahoe no crank no start after engine warms up past 160 degrees
with
Like
.
@rockola1971 any idea's? sounds like something is getting heat soaked since it only happens when it is expanded (hot) then works again...
May 10, 2024
rockola1971
reacted to
nonickatall's post
in the thread
Problems with worn valves. Need good advice
with
Haha
.
I removed today all rocker arms, inspected all valve tips and as well made a pressure loose test on all cylinders. Six of eight intake...
Apr 30, 2024
Loading…
Loading…
Forum statistics
Threads
129,534
Posts
1,817,335
Members
92,748
Latest member
Amada
Latest posts
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
Latest: Charlie207
22 minutes ago
General Discussion
J
Anyone “upgraded” from the tensioner style AC compressor to the stretchy belt?
Latest: j91z28d1
30 minutes ago
Engine & Drivetrain
OEM spare tire mount, 99 Tahoe Basic 2dr 4x4
Latest: Fless
33 minutes ago
Interior
--- Photos: SPOTTER'S THREAD (post up all years/models) ---
Latest: George B
47 minutes ago
Member Photos
T
Credit Card looking slot
Latest: TrueAt1stLight
52 minutes ago
Interior
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top