strutaeng's latest activity
-
strutaeng replied to the thread Aftermarket Kit to keep Transmission cooler.Yes, agree on the operation of the thermostat. A lot of folks will delete because it can stick (closed?) and can cause transmission to... -
strutaeng reacted to Geotrash's post in the thread Aftermarket Kit to keep Transmission cooler with
Like.
The thermostat actually does the opposite. It's intended to help the fluid warm up sooner and stay above 180ºF or so, but it's proven to... -
It’s ok on a vehicle old enough to have accumulated the rust and paint fade in patina. I think it looks silly on any other rig or when...
-
strutaeng replied to the thread Busted Lines leaking Coolant. Help. Semi-stranded..You can unhook both heater hoses from the water pump that connects at the firewall and simply connect them together with a coupling from...
-
strutaeng replied to the thread Help me decide what to do??.Axle swap is easier, but takes more heavy work. Regear is more difficult because it takes precision measurements/setup and is tedious...
-
It wasn't lifted at all I just crawled under it. N all 4 wheels were on the ground now chalking I should've known better but I wasnt...
-
normal, AWD will roll away if either end is lifted up, has no real "park" instead it binds the front/rear together unfortunate way to...
-
strutaeng replied to the thread What cam did you go with, why, and do you like it?.I used this cam on my 06 Suburban LQ4 2500 when I rebuilt the engine earlier this year. I like it. My truck has 4.10 gears with the...
-
strutaeng reacted to Geotrash's post in the thread What cam did you go with, why, and do you like it? with Like.
I went with 3 different cams before I found one I liked. The first had a little lope, which sounded good but was slightly annoying...
-
strutaeng replied to the thread Rear end gone???.What?! Truck rolled backwards after you removed the front driveshaft and pinned your leg? Are you okay? Safety first man. Parking...
-
Did you set the parking brake, chalk the wheels?
-
No kidding. This evening, I put my hood in the vertical position for my removal and install . OK, almost vertical. Tear down begins...
-
strutaeng reacted to rockola1971's post in the thread What is this hose by cam position sensor? with Haha.
OP should probably feed the squirrels better before they start chewing on engine blocks and tranny cases!
-
strutaeng reacted to viven44's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Yes this is classic MC failure if bleeding doesn’t recover the pedal or unable to even bleed… you might want to buy Autozone part with...
-
strutaeng reacted to project_x's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Is there a part number for the new "old" ones?
