OP
OP
RooTBeeRthe1st
Full Access Member
- Joined
- Jul 11, 2018
- Posts
- 1,082
- Reaction score
- 2,456
Finally posting a "build" thread. The progression of my stupidity.
- Thread starter RooTBeeRthe1st
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Charlie207
Full Access Member
Are the flanges even flat?
mikez71
Full Access Member
- Joined
- Mar 9, 2023
- Posts
- 1,144
- Reaction score
- 1,324
Ugliest welds won't be visible when installed.
They seem useable with a little touch up..
Don't like the extra EGR ports.
Factory mani looks more durable to me.
Only need one wrench to undo collector nuts..
Unless for weight savings and sound, maybe not worth the trouble?
They seem useable with a little touch up..
Don't like the extra EGR ports.
Factory mani looks more durable to me.
Only need one wrench to undo collector nuts..
Unless for weight savings and sound, maybe not worth the trouble?
OP
OP
RooTBeeRthe1st
Full Access Member
- Joined
- Jul 11, 2018
- Posts
- 1,082
- Reaction score
- 2,456
Mostly... The supply gaskets are very thick and soft.
Some of the welds from inside the runners actually protrude above the flange face.
OP
OP
RooTBeeRthe1st
Full Access Member
- Joined
- Jul 11, 2018
- Posts
- 1,082
- Reaction score
- 2,456
Well, summit thankfully returned and exchanged my ugly BBK headers with some Holly flowtech headers without issue, just took some time and a little added cost.
I should have put my calipers on the ID of those BBK primary is because they're advertised as 1.75, but the way those welds were, it was probably closer to 1.5 or smaller.
The flowtechs advertise 1-5/8, and on the flange, they are exactly that, but it does neck down immediately after to a 1.5 inch tube.
However, these welds were much cleaner and precise, and the flanges were clearly sanded flat after being fabricated, and these are for GMT 900s because they don't have any extra ports on them.
The ceramic coating is a bit different than the bbks, but still looks good.
I should have put my calipers on the ID of those BBK primary is because they're advertised as 1.75, but the way those welds were, it was probably closer to 1.5 or smaller.
The flowtechs advertise 1-5/8, and on the flange, they are exactly that, but it does neck down immediately after to a 1.5 inch tube.
However, these welds were much cleaner and precise, and the flanges were clearly sanded flat after being fabricated, and these are for GMT 900s because they don't have any extra ports on them.
The ceramic coating is a bit different than the bbks, but still looks good.
