"Suspension Issues"

oyarzunro71 · Dec 9, 2024

I bought about two months ago a 2016 GMC Yukon Denali, first I did installed a 1.5" lift at front, all good , no weird noises nor anything worng., BUT when I crank the engine it show the "suspension failure" notice on dash, and y´all know that is a killer in front of any dirver... is there anything I can do to delete/forget/bypass that signal???

Joseph Garcia · Dec 10, 2024

Welcome to the Forum from NH.

Lots of knowledgeable folks here who freely share their knowledge, experiences, and perspectives. Knowledge is power.

I hope that you will become a participating member in the Forum's discussions.

Pics of the truck, please.

First check to see that the electrical connectors going into the top of the front struts are clean and tight. Next, check to see that the connectors on the front level control actuators are clean and tight. It is possible that you disturbed them, when you installed the front lift.

Last, purchase a quality bi-directional scanner that is capable of reading deep codes, and chances are that it will point you directly to the source of your issue.

olyelr · Dec 14, 2024

Did you install brackets for the sensors? If not, that will throw a code for sure. There should have been small brackets to drop the sensor arms down so they are in the correct location.

olyelr · Dec 14, 2024

These little brackets here…

OR VietVet · Dec 14, 2024

Welcome to the forum from Oregon.

"Suspension Issues"

oyarzunro71

TYF Newbie

Joseph Garcia

olyelr

Full Access Member

olyelr

Full Access Member

OR VietVet

Multnomah Falls

Similar threads

Forum statistics

Latest posts