Search results

  1. M

    Upcoming used parts 2005 Z71-Closed sale.

    Thank you. I will watch the ad for the fuel pump module picture.
  2. M

    Upcoming used parts 2005 Z71-Closed sale.

    Ahhhh, I missed all the info in your sig, breezed right over it as fluff at the bottom. Thank you for pointing it out. I may still be interested in it, depending on cost and how much time/mileage is on it. Thank you.
  3. M

    Upcoming used parts 2005 Z71-Closed sale.

    Is the fuel pump from a Z(flex fuel engine) or T 5.3? Thank you.
  4. M

    WTB: Trunnion upgrade parts for factory rockers on 6.0 lq9

    Looking for a trunnion upgrade kit for the 6.0 lq9 engine project. Anyone have a kit for sale? What is the preferred kit to use for this? Seems like I've seen bronze and something else. Thanks in advance for heads up on one for sale.
  5. M

    Did a 6.0 swap in your 1/2T....what cam did you use in the 6.0?

    Thanks for the link on Holdener's videos, I've watched all of his early on in this build, back before the machine work was done.
  6. M

    Did a 6.0 swap in your 1/2T....what cam did you use in the 6.0?

    Thank you for the reply. I'm using 317's that are going to have a little bowl blend work, valve job and possibly cut a smidge to approach the 10.5:1 CR point. Was there a noticable difference with that cam vs using a stock 6.0 LQx camshaft if you have tried both back to back? Thanks again.
  7. M

    Camshaft for 6.0 LQ9, Sum-8718 or -8719 or similar

    If you have a cam that might fit the bill, let me know. Thanks.
  8. M

    Did a 6.0 swap in your 1/2T....what cam did you use in the 6.0?

    Pulling this thread back from the dead. Been looking at different cam options, read quite a bit about cam selection, and had pretty much decided to try the small-iish cam with big breathing heads combo that has shown good results. I had zero'd in on and located for sale, a factory GM...
  9. M

    Help me prepare for my motor swap.

    Inquiring minds want to know.....what is the purpose of the triple alternators?
  10. M

    Help me prepare for my motor swap.

    Yes the flex fuel pump FG0810 is the one you want to get. That is what your Tahoe is plumbed and wired for. It's no problem running the FF intake setup on the 6.0. You are actually better off if my research is correct because the FF vehicle has higher capacity # injectors vs. the standard...
  11. M

    Help me prepare for my motor swap.

    The 2500 Suburban has a different pump because it has a different tank than your Tahoe. It has nothing to do with the fact it's a 2500 6.0. That's what my last reply was inferring. Suburbans(whether 1500 or 2500), Escalade EXT and Yukon XL's have a larger tank that is physically larger and...
  12. M

    Help me prepare for my motor swap.

    What vehicle do you have the L59 in? Fuel pumps not the same between Tahoe and Sub......different tanks.
  13. M

    Mild 6.0L Build Suggestions?

    All great ideas. As soon as I felt the 12point socket slip for the first time, I knew I made a mistake. You got it right the first time.
  14. M

    Mild 6.0L Build Suggestions?

    I got mine out using this with a long breaker bar. CRAFTSMAN 5 Piece Bolt-Out Bolt/Nut Remover Set With Case 952160 Tool Kit NEW 24721521606 | eBay I guess I found the right amount of force with ingenuity, & no heat, and a LOT of patience to get my 04 Tahoe factory original one out. It was...
  15. M

    Mild 6.0L Build Suggestions?

    If my understanding is correct, the main difference 4l60 v 4l65 is the 5 pinion planetary gears. The way I see it is if GM found it necessary to make the 4l65(RPO M32) standard equipment in the 6.0 Escalade and Yukon Denali, then it must be for good reason as they are cheap asses when it comes...
  16. M

    Mild 6.0L Build Suggestions?

    That would be the factory with the gorilla tightened trans drain plug. Or from the way I heard it, it has to do with the design, a rubber O-ring up against the pan surface and lots of heat cycling. Mine was like that the first time I removed it too. I rounded it off and used an extractor to...
  17. M

    Mild 6.0L Build Suggestions?

    Thanks man, appreciate the offer. After watching all of Holdener's videos, I came away thinking the same thing. From a purely performance stand point, he is well respected, but daily driver duty is a different animal. It's interesting that these rods were a limited run from GM, as my...
  18. M

    Is there some digital kill switch I can put on my Tahoe?

    A friend of mine put one of these on his Super Duty after it was stolen and recovered the following day. The replacement relay can't be distinguished from the original factory relay. The relay has a transmitter in it that is activated by the key fob. No key fob to activate the relay, no fuel...
  19. M

    9.5SF Swap

    Not talking about a full float axle, the FF axle is only offered in 8 lug and all Escalades are 6 lug which is the requisite semi-float. Thanks!
  20. M

    9.5SF Swap

    So I have now seen another GMT800 14 bolt rear axle. It's in another 2wd 6.0 Escalade that recently showed up in my local LKQ yard. This one is still complete as of yesterday. Tempting to grab it for future use when my 330k miles 10 bolt dies, maybe after the 6.0 swap. I did confirm it's...
  21. M

    Mild 6.0L Build Suggestions?

    Hey, I've only made it thru 25 pages of your thread so far, and jumping to the last page I see it's fired up now. Thought I'd chime in and say you're not the only one with the Gen 4 rods with the notch. Mine came from a mid 2004 Yukon Denali engine that I picked up at the local Pick Your...
  22. M

    A/C Compressors not all the same 00-06?

    I've been looking at replacement A/C compressors and it appears there may be a difference between earlier year model SUVs (maybe 99-02) and later model year SUVs (03-06). Some appear to have two electrical plugs(one on back, and side plug for clutch) and some have only one plug (side plug for...
  23. M

    Programming mileage in a replacement cluster

    Whereabouts are you in AK? My in laws are in Anchorage and I'm up there every so often. Thanks to everyone for the pages of replies on this thread. This thread was two fold in asking. I have an Escalade cluster that I plan to use in the Tahoe, but I also pick up 7 gauge clusters to...
  24. M

    JVC-NT310 DD Nav headunit + all NBS wiring

    Just a single disc? Thanks.
  25. M

    JVC-NT310 DD Nav headunit + all NBS wiring

    Trying to find all the specs on it. Does it have built in CD player? Yes I still listen to actual music on CD.

Forum statistics

Threads
132,323
Posts
1,865,981
Members
96,917
Latest member
FredEx112

Latest posts

Top