Search results
-
Improve Towing
Vette servo is 50% more apply pressure. Vs Billet is aprox 70% more. That makes for a harsh 1-2 shift vs the vette servo.- ezdaar
- Post #4
- Forum: Engine & Drivetrain
-
Please help me plan exhuast system
Do not go smaller than your current pipes. With your mods. go with 2.5" duel with a X pipe. Or the high flow magnaflow cats and y pipe to a 3" catback. But. The way it should really be done.. Long tube headers with no cats, and one of the options above.- ezdaar
- Post #10
- Forum: Performance
-
-
Went from 0 to 2 tahoes in few weeks. From Fl
Awesome. Did you use the hand held tuner or get a real tune done? I'm looking into the 06 rubi's and the full on banks power package. But I will be using HPtuners and don't expect any issues..- ezdaar
- Post #5
- Forum: Introduction
-
Gas pump always shuts off early
yea, your question sucked. Look what a 2 second search found. -------->Click me<-------- ezdaar
- Post #6
- Forum: Engine & Drivetrain
-
Went from 0 to 2 tahoes in few weeks. From Fl
What turbo kit was on the jeep? Welcome to TYF!- ezdaar
- Post #3
- Forum: Introduction
-
Leaf Spring rattles
Bicycle tube. Slice it in 4" section then down the side to make a rubber rectangle. Remove that part. Slip the section of tube into it. Then reinstall it. While if off, use a pry bar to seperate the leaf's as much as possible and plce more of the same section of rubber between the leafs where...- ezdaar
- Post #3
- Forum: Street Suspension
-
Do these DEPO headlights fit regular Yukon?
Yukon and denali lights are interchangable. So yess they will fit. -
Gas pump always shuts off early
Its the vapor recovery system telling the pump, the tanks almost full.. This prevents spills. Its normal.- ezdaar
- Post #2
- Forum: Engine & Drivetrain
-
-
-
-
Improve Towing
Helper bags. Small portable compressor to fill them when needed. Trucool trans cooler. Vette servo billet 4th servo Go tow as much as you want. wont hurt sheet with that build.- ezdaar
- Post #2
- Forum: Engine & Drivetrain
-
Another air raid jr thread
You want mpg? Get a eco tune and install a vacuum gauge, drive with the intake vacuum as high as possible. Do no other mods.- ezdaar
- Post #3
- Forum: Performance
-
Y-pipe debauchery
LOL! Can't tell ya, its a secret. Will say this tho, its aprox 14" long, cost 48$ and its a flow through with packing.- ezdaar
- Post #34
- Forum: Engine & Drivetrain
-
Bilstein 5100 shock boot cramped
slip that boot down over the body of the shock! Not only is that boot rubbing on the shaft causing damage, the shaft will eventually wear numerous holes in that boot, allowing tons of dirt in.. almost as bad as this.- ezdaar
- Post #10
- Forum: Lifted Supension - Z71 & 4x4
-
Y-pipe debauchery
Glad you found a shop that can actually weld and knows wtf they are doing. Nice! but I really hope you thought about a flex joint. Bruh, I run LT's, no cats, 3" pipe to a single muffler, dumped before axle. the tip is angled 45* out the side in front of rear tire. Mines only alittle loud at...- ezdaar
- Post #32
- Forum: Engine & Drivetrain
-
Best place to mount a brake controller
Ive always mounted them in that location aswell. With alittle work, you could hide it inside your center console or in glove box. Given your dimensions and shin contact with it. Consider mounting it with high quality velcro, so it can be easily removed when not in use. -
-
-
2004 Yukon XL, let me know what you think
Plugs, ngk 4177, don't waste $ on fancy pants expensive plugs. Oil filter, wix 57060 Save some money, get a specter CAI, then spray it with VHT 2k header paint. Remove the steel plate below the filter. Insulate the box with hushmatt, door kit. Seal the box to hood with ebay round door trim. If...- ezdaar
- Post #4
- Forum: Introduction
-
Is there a way to fix the light leads on the gauge cluster?
Yes, use led strips to replace those crappy bulbs, cut the strips and steick them evenly inside the assembly. Solder the strips to the copper pads for bulbs. No more shitty hot spots. Get a RGBWW kit and have any color you want in your dash. If you know what a soldering iron is..... You... -
Help me choose wheels for my 87...
eeh, 6" suspension on 35's isnt sky high and it makes old school burbans look mean as hell. :)- ezdaar
- Post #9
- Forum: Other Vehicles
-
Help me choose wheels for my 87...
Lift it! every kid Loves Dads monster truck! Go big and loud.- ezdaar
- Post #5
- Forum: Other Vehicles
-
EXPERIENCED HELP NEEDED!!! fuel injector fine tuning
243's are great heads, even on a 6.0. But they do in fact drop compression. This is why everyone cuts them 30-40 thousandths, to bring compression back up.- ezdaar
- Post #13
- Forum: Engine & Drivetrain
