Search results

  1. M

    Body lift

    Zone is also a sister company to BDS I believe.
  2. M

    Body lift

    Look at the Zone Off Road BLs for pickups. They can be used on the GMT800 SUV’s as well. I have a Zone 1.5” on my Sierra. Been on there since 2009ish. They are good kits. At the 1.5” mark the only thing I had to do was relocate bumpers(front is a must/rear preference), relocate the parking...
  3. M

    Z71 roof rack on a GMC yukon xl lights ...

    You pull one of the rear mounting bolts out and run the wire through the bolt hole, down the rear pillars, then underneath the carpet to the front wherever you are putting the switch.
  4. M

    Need help sealing Transfer Case to Transmission

    There is a large o ring if I remember correctly that goes in the extension housing. Other than that, there is a paper gasket between the t case and transmission extension housing. There is no need for any type of silicone/RTV
  5. M

    5.3 Slipway while driving

    P0171 and P0174 codes could indicate a few things. Most common reason for those lean codes popping is faulty intake gaskets. You mentioned you replaced the MAF. A bad or defective MAF could also produce the lean codes for both banks. If the codes were not present before switching out the MAF...
  6. M

    3 inch lift spindles with 1-3 lift keys

    RC 6” kit is dependent upon torsion crank to achieve a full 6”. The spindles in that kit are the same as their 4” kit. The added 2” comes from torsion adjustment I believe but if I’m wrong somebody correct me. That being said, 3” spindles is only one inch shy of the spindle in the RC kit. I’d...
  7. M

    My carpet finally met its match..!

    That turned out great. I’m currently working on restoring a WJ Grand Cherokee for my sister-in-law. Will have to keep that stuff in mind if I can’t save the carpet in it
  8. M

    No sound 1994 Silverado

    All of the fuses I could find pertaining to radio were all good. Unfortunately I’m several hours away from it now. It’s on a family farm and my dad drives it mostly. I hope we can get back there again over the summer. When I get back to it I’ll take a meter and probe around. Thanks everyone for...
  9. M

    No sound 1994 Silverado

    Good morning all, Currently trying to figure something out on our 94. The truck suddenly had an issue with no sound coming from speakers. I assumed either the factory tuner/amp under the steering column or the radio itself had gone bad. The factory radio still displayed station, time, volume...
  10. M

    03 Yukon master window switch removal?

    Must be an 03-06 thing with the screw on the master switch. I’ve owned 3 different 99-02 trucks and none of them had a screw holding the master window switch down. As other members have said, the door panel is easy to get off. It will probably take all of 5-10 minutes max to just pull the whole...
  11. M

    03 Yukon master window switch removal?

    They just pop out. No screw from factory for the window switch. There are two clips that snap in. The door panel will have 3-4 screws holding it in however along with the plastic clips that lock into the door skin
  12. M

    4 corner steam kit?

    I think the number for it is 12562169
  13. M

    4 corner steam kit?

    Early LS equipped trucks (like my 2000 Sierra that originally had a T code 5.3) had a factory 4 point steam tube assembly that all ran together instead of just tying the front two together underneath the intake. That early factory assembly hugged my valley plate pretty well if I remember...
  14. M

    Delayed Crank

    Thanks for the suggestions. I’m going to pick up a pressure gauge tomorrow and make note of readings. The extended crank term is also applicable and probably more accurate one to use
  15. M

    Delayed Crank

    It doesn’t seem to misfire or stumble once started. It hasn’t triggered a P0300 or any other particular cylinder misfire code, I’m not certain what the misfire counts are and if there is variance from one bank to next. I’m going to try and get a scanner on it and also see ST/LT trims I’ll try...
  16. M

    Delayed Crank

    I think I’m going to try and get my hands on a smoke machine this week as well.
  17. M

    Delayed Crank

    From dead cold, cranks starts immediately. After that there is a delayed crank issue until cold again. Delayed crank meaning turning switch it turns over but does not start until 4-5 key cycles. Once it’s hot it will still eventually start after the 4-5 key cycles/attempts. Once started it runs...
  18. M

    Delayed Crank

    From dead cold, cranks starts immediately. After that there is a delayed crank issue until cold again. Delayed crank meaning turning switch it turns over but does not start until 4-5 key cycles. Once it’s hot it will still eventually start after the 4-5 key cycles/attempts. Once started it runs...
  19. M

    Delayed Crank

    Good morning all, I’m having a little issue with my Sierra that I can not run down for the life of me. It has a delayed crank. For a while it was 2-3 key cycles before she would hit, and now it’s like 3-5 cycles even with pause after turning switch on. It’s like there is an immediate residual...
  20. M

    295 70 17 Trail Grapplers 2.5/0 lift

    Lovin the stance and how much those 295s fill the wheel wells. Makes me miss my snowflakes too. Looks great
  21. M

    2006 Tahoe Body Mount and Bolt Size

    No problem. I know how hard it can be to find info and items from time to time and willing to help a fellow member anytime I can.
  22. M

    2006 Tahoe Body Mount and Bolt Size

    where are you located? I have all the factory hardware off my Sierra before I put my BL on. The hardware is the same for trucks and SUVs. PM me you address and I’ll send you some OE bolts
  23. M

    Caliper G80 axel

    Man that stinks. We take for granted here having so many different types of goods and supplies readily available. I’ll bet core charges on hard parts are a nightmare for you regarding shipping back and all. I’d be tempted to buy rebuild kits and bench build old parts as they get replaced so you...
  24. M

    Caliper G80 axel

    My apologies. I missed the VIN and RPO link originally. It looks like the ribbed dual pistons are the ones for your 4wd. I think all the limited slip (G80 RPO) vehicles had dual piston rear setups. The non limited slip coil sprung rear axles were packaged with the same single piston caliper...
  25. M

    Caliper G80 axel

    According to the catalogs I’ve looked from the big suppliers, it looks like there is two different options for rear calipers on 2WD 2002 Tahoes and both are dual piston. One of the of the caliper castings is smooth, the other is ribbed. There is only one option for a 4WD 2002 Tahoe and it’s dual...

Forum statistics

Threads
132,707
Posts
1,872,890
Members
97,522
Latest member
onyx24

Latest posts

Top