Sorry for the late reply. I haven't even realized but the squeaking stopped. I wonder if spraying grease everywhere eventually got into what was squeaking. I sprayed everything that moves lol
Looks like I have, it wasent leaking too bad at the time and it's gotten worse. So need to get it done now and just want to be prepared. For the sheild on the pressure relief valve do I need it if my vehicle does not have afm? Or install it anyways? I've seen some post where people just plug it...
Thank you. My cold pressure and cruising pressure seems ok. Hot idle does get sort of low. I plan on doing the valley gaskets but want to get the oil pan done first since it's leaking.
Going to be replace the oil pan gasket as it's leaking, and the pick up tube o-ring. Should I go OEM gasket and o-ring? Is there a better aftermarket choice?
I've also read that vehicles without dod/afm can plug the pressure relief valve. Should I plug it? I want to make sure I get what needs...
I've seen videos of them doing it for the front one on top of the driver seat, can I do it the same way for the one in the rear? It's a bit more towards the middle of the vehicle
I need to replace that air aspirator in the rear of my yukon xl. Does anyone know how to get to it? I don't want to ruin the headliner by tugging on it. The fan in it is very noisy I want to replace it. Thank you!
Yea I believe it's a hiss not static. When I attempted to add the ground the additional noise was on top of the hiss. I don't know much about the factory amp.
This head unit I got came with the complete harness. My factory back up camera works. Rear entertainment and screen works. Even the on...
I had Amazon send me a replacement and there's still the static/ white noise. So I'm assuming it's something with my truck. I spoke to a couple people on a fb group that have the same head unit in their denali with no issues. I'm not that experienced with electronics so I'm not sure what can be...
Seems like you were right. I attached a wire to the ground pin that they told me to use. Anywhere on the vehicle I touched the other end to made an additional static sound with a low pitched buzzing sound as well. So I believe the ground isn't the issue.
Well the company contacted me, they helped me lower the volume through the radio settings. But I still have static they recommended me to ground the radio to the frame of the vehicle
Thanks for the reply. From the research I've done seems the bose system is usually the issue. They advertise that's its plug and play and works with factory bose system. Still waiting for them to reply. Other than that everything is working.
2007 gmc yukon xl denali with factory navi and bose.
I just installed a head unit from eonon model #GMA12S-6G. Theres a static playing from the speakers that will stop if i mute the radio or volume 0. I aslo noticed the radio is pretty loud. Even level 1 is louder than it should be. Im not too...
Hey everyone I used my 2007 gmc yukon xl denali today to pull a dump trailer with soil to the back of my land. I ended up spinning my tires a bit in some soft ground. While traction control was active all the light interior and exterior were flickering is that normal? My alternator is afew...
Hey everyone, as the title says. My brake pedal itself squeaks and creaks even with the slightest touch. I sprayed everything I can see that moves/pivots. I must've pressed the pedal 100s of times trying to figure it out but I can't. Any ideas? It's extremely annoying.
Thanks, I came across this I just wasn't sure if it would keep my highs on with lows since by factory default they are supposed too. Also didn't care about the fogs going on with the highs. But if it will allow me to run the lows and highs then I wouldn't mind.
Hey everyone I have an 07 yukon xl denali. The oem headlights uses a single bulb for low/hi. I have some aftermarket headlights that use separate bulbs for the low/highs.
Does anyone know how I can keep the low and highs on at the same time? I previously owned an nbs yukon and remember using...
My car charger shows the voltage. It seems when voltage drops the led bulb is getting brighter which is weird. When the truck is running its at its usual 14ish volts. Once I shut it off its around 12.xx volts.
Also when hitting the window switches the volts drop for a second till the...
I recently installed some aftermarket headlights with LED bulbs I purchased. I realized today when ever I pressed anything that uses electric the bulbs will get brighter for a second. For example closing a window.
Then when I shut the vehicle off the lights got much brighter and stayed brighter...
Hey everyone I have a 2007 yukon xl denali that I purchased just about a year ago. I installed some aftermarket headlights yesterday and it made me realize I have a decent size gap under the headlight and between the bumper. Also catching my attention was the gap between my hood and bumper. I...
I have a 2007 yukon xl denali. Non afm.
I currently have 89k miles. On a cold start with fresh oil and filter I have just under 60 psi I'd say around 55psi once everything is warmed up the pressure is under 20 psi around 10-15 psi. Cruising at lower speed it'll be just under 40 psi highway speed...
Thank you I ended up ordering this before seeing your reply but it looks similar. Appreciate the info I'll just snug the bolts down a bit and check for leaks over time.
So I took a look under. It's hard to see exactly what's going on because I have an oily undercoating on my denali.
But I can see for sure the oil cooler block off is leaking.
Do I need to drain the oil before swapping it out?
I'll start with the block off plate since I can see for sure that's...
Hey everyone, I just changed my oil today and realized I have a leak somewhere. Seems to be the oil pan gasket. I know how much work is involved to take the pan out being an AWD so I'll most likely have a shop do it. Since I'll have the pan out I'll have the shop do the pick up tube o ring as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.