1000 point question

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Spacido

Full Access Member
Joined
Feb 26, 2019
Posts
120
Reaction score
165
Location
Saint Cyr les Colons - France
Hi everyone and a question that may seem stupid to you ...

I note that there are orange lights on the roof of the US truck. Is it mandatory in the USA?

Why do some trucks have them and no others?

I think it's nice and I installed on my Jeep, I think the Tahoe will have too :anitoof:.
Let's say, it's for my personal culture :waytogo:
 

PG01

Supporting Member
Joined
Nov 6, 2016
Posts
14,967
Reaction score
18,578
Location
Up here to the right
They are actually called clearance lights

The front identification lamps are typically mounted atop the cab of vehicles. The purpose of these lamps is to alert other drivers to the presence of a wide (and usually, tall) vehicle. This type of identification lamp can also be found on road trains in Australia.
 
OP
OP
Spacido

Spacido

Full Access Member
Joined
Feb 26, 2019
Posts
120
Reaction score
165
Location
Saint Cyr les Colons - France
Thanks for your precisions.

On the Tahoe record, they were talking about these optional clearance lights.

Here it's a little more exotic :anitoof: I'll see to put it on my Jeep. I have to put a switch to extinguish at will because it does not pass the technical control that we have on our vehicles every 2 years.
 

grouch

Full Access Member
Joined
Jan 23, 2019
Posts
1,490
Reaction score
3,620
Hi everyone and a question that may seem stupid to you ...

I note that there are orange lights on the roof of the US truck. Is it mandatory in the USA?

Why do some trucks have them and no others?

I think it's nice and I installed on my Jeep, I think the Tahoe will have too :anitoof:.
Let's say, it's for my personal culture :waytogo:



They are required on heavier GVW vehicles. Some 3/4 ton trucks have them and all 1 ton and heavier specification trucks have them. The problem with just adding them is you're adding holes to the roof. Be sure to use clear RTV silicone, ESPECIALLY on the screws so it doesn't rain inside when it rains outside.
 
OP
OP
Spacido

Spacido

Full Access Member
Joined
Feb 26, 2019
Posts
120
Reaction score
165
Location
Saint Cyr les Colons - France
Yes indeed I will ensure the shot with silicone.
Analyze how to mount all this and I must see also for the DRL which is inoperative on my truck, for so I have my fuse and relay.
 

mountie

Supporting Member
Joined
May 9, 2018
Posts
4,696
Reaction score
8,622
Location
Wellington, Fl., (formally Kalifornia)
Silicone will eventually separate from surface......

Use a tube of "Gutter Sealant".... ( for rain gutters- Check it out at ACE Hardware, etc.).... WAY better for the application.
And very waterproof / heat proof.
 
Top