1999 2 door Tahoe rust repair

[Camoman]

Folks I found some rust between the passanger door down low and the wheel well. I guess the rocker panel is easy to find but two shops said there were no pre made skins they could cut off the old and weld in the new? Anyone know if these are still made and where I could get them?

Thanks
CM

 

[Gzes]

Gonna be hard to find. But they are correct find a non rotted out donor and cut the good pieces. Too bad you dont live in the south. We got 2 2drs down here in a yard i go to not a spec of rust like all southern rides

 

[96redsport]

I got the same issue and went looking for a source and I found these guys.....

http://raybuck.com/ag-83038.83054.83094.83113-1996-chevrolet-truck-suv-tahoe.html

 

[Camoman]

I got the same issue and went looking for a source and I found these guys.....

http://raybuck.com/ag-83038.83054.83094.83113-1996-chevrolet-truck-suv-tahoe.html

Thanks for the site.
Did you use a front lower on the rear?? I did not see the back panel behind the door?

 

[96redsport]

Yes lower front quarter section. Goes between the door and the rear wheel well.

 

[JacobYamaha]

Hey I was just wondering if a truck box would work to to patch up the rear of my Yukon two door??
Because I found a who rear corner panel brand new but withe the Canadian dollar I'm looking at 1000 bucks each side

 

[SunlitComet]

not sure. the hoe has stiffeners and stuff under all the trim.

 

[SunlitComet]

try finding a scrap hoe with good paneling to transplant.