2-3/4 drop question

[rollin23s]

I have a belltech kit and I plan on dropping my truck this weekend. I have spindles up front and springs in back. I currently have 23s on with a 305/40/23 tire, should I be concerned about rub? Do I need to take anything else into consideration? I will post some before pics tomorrow, my goal is a new cruiser look not real low.

 

[Red_Raider]

I have a 2/3 installed on 305/35/24s. I have a little rubbing up front on full lock turns. Not sure about 23s though. Might have to do some modding up front.

 

[CHOO CHOO]

You can trim the fender wells or heat them up and mold them. I had a little trouble, but honestly i let alone and it just wore off eventually.

Sent from my DROID4 using Tapatalk 2

 

[rollin23s]

I appreciate it, anything I should do to make sure it doesn't squeak post drop? I had buddy that dropped an impala and it sounded horrible.

 

[Knobz]

You can trim the fender wells or heat them up and mold them. I had a little trouble, but honestly i let alone and it just wore off eventually.

Sent from my DROID4 using Tapatalk 2

+1 haha that's what I did up front.. Just let it wear out and after a cpl months no more rubbing..

 

[rollin23s]

So Finally I did the drop

The first pic is a before and the second pic is an after. I did the 2/4 drop first but I didn't like the look. The 2/3 drop is what I settled on and it rides really nice. Next up is the radio.

 

[Cobra]

sits nicely

 

[blue99tahoe24]

lookin good

Sent from my SGH-T989 using Tapatalk 2

 

[Pachanga02]

Looks good I like the stance.

 

[rollin23s]

Thanks. I haVe a system to put in next then it is onTo performance mods