2001 Tahoe remote control fob

[giobri]

Hello, I'm a newbie, I write from Italy.
I am not be able to link a new fob (transmitter) to my Tahoe 2001: I made the following instructions but unsuccessful.

1.Close all vehicle doors.
2.Insert the key into the ignition.
3.Hold down the power UNLOCK button on the driver’s door panel-continue to hold
down until instructed to release in step 9.
4.Perform steps 5 through 8 in fairly rapid succession.
5.Turn the ignition switch to the ON position (as far as you can go without starting the
engine).
6.Turn the ignition switch to the OFF position.
7.Turn the ignition switch to the ON position.
8.Turn the ignition switch to the OFF position.
9.Release the power unlock button on the door panel. The vehicle will lock and unlock
the doors automatically.
10.Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until
the door locks and unlocks.
This step may take up to 30 seconds.
11.Repeat step 10 NOW for each additional transmitter (including any existing
transmitters).
12.Turn the ignition switch to the ON position in order to exit the transmitter programming mode.

Someone could help me?
Thank you
Giovanni

 

[OKLAGMCRUISER]

welcome to the forum! I'm sure a member has ran into this same issue and will chime in soon to help!

Pat

 

[giobri]

Thank you Pat

Giovanni

 

[giobri]

The real problem is that, performed the first steps (Unlock hold, on-off-on-off) the car does NOT lock and unlock by itself to pass in to the programming mode. Maybe a problem with the car and not with the fob???

 

[giobri]

Maybe that my Tahoe isn't equiped with the keyless entry reciever?

 

[Repo503]

That all sounds correct, I believe all gmt800 tahoes have keyless...it could be the receiver is just not working. I'm not sure where its located on these trucks.

 

[tast101]

Or you could have the wrong key FOB.

 

[OmarR]

Giobri, do ANY of the steps work?

 

[giobri]

I did all the steps several times, I think in the correct way: as I wrote, the car doesn't lock-unlock after the "U key hold down/ON-OFF-ON-OFF" operation....
The second fob is the same of the working one...

 

[T3rry]

try different key positions, i know when i had to do mine in my Grand am, i had to go from off to accessory and back, i think it should only need to go one "tick" so if you go off to accessory and back again, that might work, if not, try accessory to on, or something similar, i am pretty sure you can only go one tick though.