2003 Yukon NO COLD AIR (I'M MELTING)

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

campbmic

Member
Joined
Mar 5, 2014
Posts
30
Reaction score
1
A/C seemed to have been going out earlier in the spring (only kicking on sometimes). I stopped driving the truck for about 5 months and now I have absolutely no A/C. I live in Texas so this is killing me!

How can I tell if I'm out of freon or the A/C compressor needs replacement or something else?

BTW I think I've located the A/C compressor and it looks like the middle/face of it is not spinning. With the A/C on I can spin the middle/face with my hand. If this is the problem would I replace the whole compressor or just part of it?

Thanks!
 

Sasquatch

Full Access Member
Joined
May 3, 2009
Posts
1,249
Reaction score
388
Location
Orange County N.Y.
If you`re low on freon the compressor will kick on for a few seconds and go off. It will kick on and off repeatedly. If you have a leak and have no freon it won`t come on at all.

You can try to throw a few cans of R134a in there and see if the compressor comes on again. If you`ve never done it before fill the system with the engine running and the AC on.

I think you may have a leak and they do make a R134a stop leak if that`s the case.
 

05alive

Full Access Member
Joined
Mar 2, 2015
Posts
413
Reaction score
314
Location
Masshole
See if you can spin the compressor by hand. If I remember correctly it's low down on the passenger side. If it spins, move to checking the freon.

Also check the stupid stuff- an anecdote: Mine went earlier this year. I checked the compressor and the wheel spun. Checked the freon and it was full.
Then the D'oh moment hit- The AC belt wasn't there. Completely gone. No trace. The belt tensioner had broken, and the belt slipped off. New tensioner, new belt, and I was running ice cold.
 

retiredsparky

Full Access Member
Joined
Jul 9, 2016
Posts
379
Reaction score
121
If the clutch goes out, it can damage the front bearing on the compressor from excess heat and take out the seal. This will cause a leak and the compressor will not run until the freon is at minimum pressure to satisfy the low pressure switch (after finding location of leak).
 

Forum statistics

Threads
132,425
Posts
1,867,925
Members
97,105
Latest member
Jellis02
Top