2004 Tahoe A/C high/low pressures

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

ueww40

Member
Joined
Aug 5, 2017
Posts
43
Reaction score
17
The other day I went out and got myself a beautiful professional A/C manifold gauge set to check the status of the A/C system on my 2004 Tahoe. As far as the proper pressures of the system are concerned the instructions on how to use the set say to follow the manufacturer's recommendations. I am confused now. I always thought that all automotive A/C systems operate within the same perimeters. A fully charged, properly working A/C system should be around 50 psi on the low side and around 250 psi on the high side +/- allowances for ambient outside temps. Is that correct? Or are these specs different for my Tahoe which has front and rear separately controlled A/C. The reading I got on my Tahoe was 60 psi on the low side and 265 psi on the high side at an outside temp of 87 F. Is that a good reading?
 

PNWYukon

Full Access Member
Joined
May 13, 2015
Posts
300
Reaction score
239
Location
Olympia, WA
A/C Refrigerant Pressure Sensor
The A/C refrigerant pressure sensor is a 3-wire piezoelectric pressure transducer. A 5 volt reference, low reference, and signal circuits enable the sensor to operate. The A/C pressure signal can be between 0-5 volts . When the A/C refrigerant pressure is low, the signal value is near 0 volts. When the A/C refrigerant pressure is high, the signal value is near 5 volts . The PCM converts the voltage signal to a pressure value.

The A/C refrigerant pressure sensor protects the A/C system from operating when an excessively high pressure condition exists. The PCM disables the compressor clutch if the A/C pressure is more than 2957 kPa (429 psi) . The clutch will be enabled after the pressure decreases to less than 1578 kPa (229 psi).

A/C Low Pressure Switch
The A/C low pressure switch protects the A/C system from a low pressure condition that could damage the A/C compressor or cause evaporator icing. The HVAC control module applies 5 volts to the A/C low pressure switch signal circuit. The switch will open when the A/C low side pressure reaches 151 kPa (22 psi) . This prevents the A/C compressor from operating. The switch will then close when A/C low pressure side reaches 275 kPa (40 psi) . This enables the A/C compressor to turn back ON.
 

OR VietVet

Multnomah Falls
Supporting Member
Military
Joined
Oct 8, 2014
Posts
20,688
Reaction score
36,425
Location
Willamette Valley
Humidity will/can make a difference as well. What was the temp at the front dash center vent? Temp on high fan? Temp on low fan?
 

Forum statistics

Threads
132,237
Posts
1,864,502
Members
96,785
Latest member
Jack23fcb
Top