2006 gmc yukon xl slt option 2 electrical

[Woodblocker55]

Ok I got new throttle body with module . Coming I see how to install it .. but is there a learning cycle I have to do ..like a drive cycle then reset check engine light. ??? Is that all ?


Sent from my LGL722DL using Tapatalk

 

[mwilson62000]

I’ve never found an official relearn procedure. I would disconnect negative battery cable, then replace throttle body. Once you hook everything back up and start it, idle could be a little off until it learns a bit. Just drive it.

 

[Fless]

Ok I got new throttle body with module . Coming I see how to install it .. but is there a learning cycle I have to do ..like a drive cycle then reset check engine light. ??? Is that all ?


Sent from my LGL722DL using Tapatalk

Doesn't the Tech 2 have an idle relearn for the DBW TB?

 

[mwilson62000]

Doesn't the Tech 2 have an idle relearn for the DBW TB?

I thought it did too, but when I did mine, my neighbor brought home his tech2 and and we couldn’t find a relearn, just where we could show parameters of the movement of the throttle blade.

 

[Fless]

I thought it did too, but when I did mine, my neighbor brought home his tech2 and and we couldn’t find a relearn, just where we could show parameters of the movement of the throttle blade.

Curious. I'll have to pick through my menus again since I'm not sure if it's there.

 

[Woodblocker55]

Here is the one thats on 2006 yukon xl 5.3L. I checked like 4 places for new GM number and it matched Rock Auto number . So hope it's right one . Is it same throttle body as 6.0 it said on carid.com.[emoji849][emoji849]

Sent from my LGL722DL using Tapatalk

 

[Woodblocker55]

2006 gmc yukon xl slt 185,000 miles I got the code P2108 and U0107 .. I bought a new throttle body with controller. But I just came across this on the internet.you think it's possible that the guy that owned it before never updated it from 2006 on the PCM.

It trip these codes when I use the remote start. So it trip those codes when not in motion. Any ideas??

Sent from my LGL722DL using Tapatalk

 

[Woodblocker55]

Is there a way to tell if they updated the PCM in 2006 ?? With scanner ?

Sent from my LGL722DL using Tapatalk