2010 Burb z71 Rear axle replacement??

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

pt1965

Member
Joined
Dec 24, 2009
Posts
78
Reaction score
20
Location
columbia,sc
i accidently kept my 2010 burb z71 in 4wd high after leaving boat ramp and drove 30minutes home. ussually i can tell its in 4wd when turning but i didnt notice anything while towing. then a week later the rearend is locking up and making a loud sound when unlocking. my shop says it needs replacing or rebuilt which they dont do.
did that one incident ruin my diff??
 

Doubeleive

Wes
Supporting Member
Joined
Nov 7, 2017
Posts
26,531
Reaction score
39,945
Location
Stockton, Ca.
not likely, if anything you might have put more wear on the front tires when turning
 
OP
OP
pt1965

pt1965

Member
Joined
Dec 24, 2009
Posts
78
Reaction score
20
Location
columbia,sc
shop quoted 2400 for used axle. found a rebuild guy and dropped it off there. we'll see what he says.
 

swathdiver

Full Access Member
Joined
May 18, 2017
Posts
19,805
Reaction score
26,751
Location
Treasure Coast, Florida
Used are less than half that and new ones are about that last time I looked. Leaving it in 4HI did not cause it, it was probably getting tired and pulling the boat out of the water probably did it in.

This is the time to swap in a 9.5" (AXN) semi-floater from a 2WD SUV with the 6.2 or a 4x4 with the 6.2 (rare).
 

Tonyrodz

Resident Resident
Joined
Feb 16, 2012
Posts
31,719
Reaction score
47,466
Location
Central Jersey
Used are less than half that and new ones are about that last time I looked. Leaving it in 4HI did not cause it, it was probably getting tired and pulling the boat out of the water probably did it in.

This is the time to swap in a 9.5" (AXN) semi-floater from a 2WD SUV with the 6.2 or a 4x4 with the 6.2 (rare).
I think my Express van has that rear in it. Pretty sure I saw a paper tag on the rear with AXN on it. That possible James?
 

ChrisYukon

Member
Joined
Jul 9, 2018
Posts
94
Reaction score
67
$2,400 for used is outrageous. You’ll need to get it diagnosed first, but no need to replace everything if just the gears are shot.
 
OP
OP
pt1965

pt1965

Member
Joined
Dec 24, 2009
Posts
78
Reaction score
20
Location
columbia,sc
i found a rear end specialist and he rebuilt it for $1250 he didnt have much good to say about the design of these newer models. there just no built to last as long
 

rodolo

TYF Newbie
Joined
Sep 27, 2019
Posts
1
Reaction score
0
I'm doing this tomorrow. I found an axle by vin code at the auto recycling yard for $290.
 

Forum statistics

Threads
132,780
Posts
1,874,218
Members
97,624
Latest member
piranha4201
Top