5.3 Lifter Help

[jjones434]

I have a new to me 2011 5.3L Yukon. Cam, Lifter & DOD delete was previously done with a "tune". No hard data on what was installed i do know they kit was from BTR. Week after purchase heard a lifter tick - had a shop confirm it was a lifter. I would like to go back to stock cam/lifter with DOD delete, is that an option? I've seen various opinions and I am normally a EURO person tinkering in Audi/VW so this is all new to me.

I was looking at this kit Part Number: CLMC1383 - Melling Branded and getting PCM sent off to have DOD deactivated and return whatever other values to stock.

Any input, advice or help?

 

[Joseph Garcia]

Welcome to the Forum from NH.

Lots of knowledgeable folks here who freely share their knowledge, experiences, and perspectives. Knowledge is power.

I hope that you will become a participating member in the Forum's discussions.

Pics of the truck, please.

I'm a little confused. You say that the Delete was performed by a tune, and then you refer to a 'kit' from BTR. A tune only Delete does not use a kit, but a full mechanical Delete does use a kit.

Which is it?

 

[Marky Dissod]

I'd like to go back to stock cam/lifter with DOD delete, is that an option?

Why not? GM offered three 5.3L Gen4 V8s built specifically LACKING any V4 mode hardware.
Obviously V4 mode would also have been disabled in the software for such lucky 5.3L V8s: LH8, LH9, LMF.

 

[swathdiver]

I have a new to me 2011 5.3L Yukon. Cam, Lifter & DOD delete was previously done with a "tune". No hard data on what was installed i do know they kit was from BTR. Week after purchase heard a lifter tick - had a shop confirm it was a lifter. I would like to go back to stock cam/lifter with DOD delete, is that an option? I've seen various opinions and I am normally a EURO person tinkering in Audi/VW so this is all new to me.

I was looking at this kit Part Number: CLMC1383 - Melling Branded and getting PCM sent off to have DOD deactivated and return whatever other values to stock.

Any input, advice or help?

Your engine almost certainly had AFM deleted and turned off in the tune.

Besides the noisy lifter, what don't you like about the performance of the camshaft?