AMP Research Power Steps

[Undeserving]

Searched but didnt find anything more recent then 2015 or so. Anyone have these steps on a 2016 or newer Suburban? I hate the look of running boards hanging down so these appeal to me. Not sure its worth $1400 to me though. Says 4 hours to install?? Really? Seems pretty straight forward using factory holes. No drilling or cutting into existing wiring is my understanding. Is this correct? Any pics of them in the up position from a low angle, just wondering how tight they tuck up under the door. Thanks

 

[Matt_]

Install is pretty straight forward. Bolting them up is the quick part, but then you have to run the wiring and tap into each door sensor so every door will activate the steps.

 

[yates ™]

Install was easy but, if I remember correctly, did take a few hours without rushing. They also, for most models, make them PnP now and just plug into the OBD2 port.

 

[Matt_]

They also, for most models, make them PnP now and just plug into the OBD2 port.

That would have been nice!

OTOH, pulling the panels up on the passenger side identified my water leak issue that I didn't know about...

 

[yates ™]

76127-01A should be the plug and play steps. I do not see any reason they would not completely fold up but I would ask prior to purchase.

 

[lynxnova]

Can anyone post pictures of there Tahoe’s or eskys with the amp power steps? Just want to see how they look compared to the factory power steps. Contemplating on which ones to put on. Thanks in advance


Sent from my iPhone using Tapatalk