Belltech 1019 2/4 drop… rear end is high, too high??

[Wolfpack79]

I was wrong about the rod length. My apologies

 

[slupie]

Thanks so much. This definitely does help! I am going to show to the bf so he can do it.

Also I’m kind of miffed that the belltech instructions say to put it at 3inches. But oh well, so relieved to have found what the problem is.

Reread the instructions, it is supposed to be 3" from the center of the rod eye to center of rod eye. I have just installed the same kit few months ago and mine dropped about 3" in the rear. Did you mark the level sensors as the instructions said to make sure it's back in the correct position?

 

[dani_yellz]

Reread the instructions, it is supposed to be 3" from the center of the rod eye to center of rod eye. I have just installed the same kit few months ago and mine dropped about 3" in the rear. Did you mark the level sensors as the instructions said to make sure it's back in the correct position?

I believe he did mark them.

 

[dani_yellz]

Just wanted to give an update that everyone’s suggestion about the sensor rod was correct.

Now we’re looking good.

 

[iamdub]

Just wanted to give an update that everyone’s suggestion about the sensor rod was correct.

Now we’re looking good.

View attachment 361767

Much better! It's gotta ride softer in the rear now, too.

 

[Joseph Garcia]

Thank you for posting the solution to your issue. Our collective knowledge base has been increased.

 

[Wolfpack79]

What length did you end up setting it to?

 

[olyelr]

What length did you end up setting it to?

Most likely to what the directions stated.

 

[dani_yellz]

Much better! It's gotta ride softer in the rear now, too.

Yeah super soft. Feels like a boat now! lol The ride is very smooth, cant complain!

 

[dani_yellz]

What length did you end up setting it to?

I asked my bf if he remembered. He said he thinks 2-5/8''.

He said he cut off half the threads on each side of the supplied belltech rod and screwed it all the way in.