Code P0700 and P182E - Need help

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

kevshoe

TYF Newbie
Joined
Aug 27, 2011
Posts
19
Reaction score
4
Hi all. Background. 2011 Suburban (I know...it's not a Tahoe but I have two of those as well :) ). This is the wife's daily driver. About a month ago, she had these two error codes show. It also showed stabilitrak and traction control were disabled along with putting the car in limp mode. She was close to home so got it back no issues. I cleared the codes and took it for a drive. No issues. Did a quick search on the internet to see if I could diagnose the issue, but didn't find anything.

Tonight, as she was coming home, it happened again but this time did not go into limp mode (traction control and stabilitrak were both disabled again). I pulled the codes and then drove around the neighborhood and it drove fine. I then came back home and cleared the codes and took it for another spin and it did not set the codes.

Not sure where to start looking with this one so any help would be appreciated.

Thank you much in advance.
 

HiHoeSilver

Away!
Joined
Feb 28, 2017
Posts
10,918
Reaction score
14,572
Location
Chicago
Trans codes. Start simple and check the wiring at the harness. I think there's a sensor you could try, too.
 

Kraig

Full Access Member
Joined
Nov 21, 2015
Posts
202
Reaction score
98
Make sure your shift cable is not kinked or bound up somehow and check that the selector switch attached to the trans is not damaged or the connector is not janky in some way.
 

Forum statistics

Threads
133,037
Posts
1,878,786
Members
97,999
Latest member
Lilmule
Top