Coolant leaking from transmission cooler line

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

muncie21

Full Access Member
Joined
Sep 25, 2010
Posts
147
Reaction score
68
I have a 2014 Yukon XL Denali with the 6.2 motor. I recently noticed that there's minor coolant leak/seep from the transmission cooler line, where it connects to the radiator side tank on the driver's side of the vehicle.

Thinking of tightening the fitting where it connects to the radiator, however I'm a bit concerned about cracking the plastic tank when I do this. Alternatively, does anyone know if there's an o-ring in this connection? If so, I may try to just replace the o-ring before I spend $$ on a new radiator and transmission line.
 

wjburken

Supporting Member
Joined
Dec 26, 2017
Posts
9,937
Reaction score
27,457
Location
Eastern Iowa
I have a 2014 Yukon XL Denali with the 6.2 motor. I recently noticed that there's minor coolant leak/seep from the transmission cooler line, where it connects to the radiator side tank on the driver's side of the vehicle.

Thinking of tightening the fitting where it connects to the radiator, however I'm a bit concerned about cracking the plastic tank when I do this. Alternatively, does anyone know if there's an o-ring in this connection? If so, I may try to just replace the o-ring before I spend $$ on a new radiator and transmission line.

If you are seeing coolant, replacing the o-ring or tightening the connection will not help. You most likely have a crack in the radiator around the transmission line.
 

OR VietVet

Multnomah Falls
Supporting Member
Military
Joined
Oct 8, 2014
Posts
20,667
Reaction score
36,356
Location
Willamette Valley
If the line unthreads from the radiator ok you should not need a line. If you are leaking coolant from the line itself then you have coolant in your trans fluid. The only thing that should leak from the line is trans fluid. If you are talking about the fitting in the radiator, do not try to tighten. You will likely crack the radiator. If the fitting is leaking at the radiator then you need a radiator. Pics?
 
OP
OP
M

muncie21

Full Access Member
Joined
Sep 25, 2010
Posts
147
Reaction score
68
The leak is definitely coolant and coming from where the fitting screws into the radiator. Found out that the auto parts place around the corner carries just the fitting. May try to replace it with a new one and o-ring before ordering a new radiator.

large.jpg
 

wjburken

Supporting Member
Joined
Dec 26, 2017
Posts
9,937
Reaction score
27,457
Location
Eastern Iowa
The leak is definitely coolant and coming from where the fitting screws into the radiator. Found out that the auto parts place around the corner carries just the fitting. May try to replace it with a new one and o-ring before ordering a new radiator.

View attachment 236471
If you take that fitting out, you better hope only transmission fluid comes out. If coolant comes out, you need a new radiator and a transmission flush.
 
OP
OP
M

muncie21

Full Access Member
Joined
Sep 25, 2010
Posts
147
Reaction score
68
If you take that fitting out, you better hope only transmission fluid comes out. If coolant comes out, you need a new radiator and a transmission flush.
Good point. Hmmm, sounds like a new radiator needs to be added to my Santa list
 

OR VietVet

Multnomah Falls
Supporting Member
Military
Joined
Oct 8, 2014
Posts
20,667
Reaction score
36,356
Location
Willamette Valley
I have a similar problem now except it feels like a hard transmission shift. It mostly happens when cold and rolling down the street out of my driveway. As I make a slight right turn and am about to give it some gas it hard clucks into another gear.

The leak is definitely coolant and coming from where the fitting screws into the radiator. Found out that the auto parts place around the corner carries just the fitting. May try to replace it with a new one and o-ring before ordering a new radiator.

View attachment 236471


Like Wade said, careful when you attempt to tighten. If is loose that means at one time you or a tech may have loosened the LINE and did not put a wrench on the fitting to hold it in place. Shit happens.
 

kbuskill

***CAUTION*** I do my own stunts!
Joined
Mar 11, 2017
Posts
5,306
Reaction score
8,313
Location
NE. FL.
I have a 2014 Yukon XL Denali with the 6.2 motor. I recently noticed that there's minor coolant leak/seep from the transmission cooler line, where it connects to the radiator side tank on the driver's side of the vehicle.

Thinking of tightening the fitting where it connects to the radiator, however I'm a bit concerned about cracking the plastic tank when I do this. Alternatively, does anyone know if there's an o-ring in this connection? If so, I may try to just replace the o-ring before I spend $$ on a new radiator and transmission line.


FYI...

if the lines you are looking at go to the drivers side of the radiator then those are for the engine oil cooler NOT the transmission.

Transmission lines go into the passenger side of the radiator.
 

wjburken

Supporting Member
Joined
Dec 26, 2017
Posts
9,937
Reaction score
27,457
Location
Eastern Iowa
FYI...

if the lines you are looking at go to the drivers side of the radiator then those are for the engine oil cooler NOT the transmission.

Transmission lines go into the passenger side of the radiator.
I completely missed the “driver’s side” statement.
 

PoorMansEscalade

TYF Newbie
Joined
Feb 16, 2019
Posts
17
Reaction score
22
Location
New jersey
You most likely need a radiator, gm has a bulletin about this. They are blaming the thermostat for the problem. I believe there is
 

Forum statistics

Threads
132,200
Posts
1,863,849
Members
96,721
Latest member
01GrnMchn
Top