denali console

[blue99tahoe24]

Oh guys i was at the bone yard today and stumbled upon a 1999 denali and it still had the console in it and its only 12 bucks but i couldnt get it out what i wanna know is how do u remove it w/o breaking it im thinkin about dropping it in my hoe if its still there tomarrow if i decide to keep the console i have ill just sell it.thanks in advance

 

[slipping]

After you remove screws in lid, bucket and cup holder/cubby section, take lid off bucket out and the cup holder section slides backwards because its held by 2 tabs in front. You'll see two (could be a few more) bolts holding it to floor. Once bolts are removed there is a tab in the back that is holding it in place (you'll see it). Either remove the tab or gotta push the bottom of the console forward to slip out of the tab. I used this method to install and remove from my Tahoe. Should be the same +/- a few bolts.

 

[blue99tahoe24]

Thanks bro i hope no one will get it while im at work

 

[Monstar_est87]

Theres 2 bolts it the cup holder... Once u get that front part off theres like 6 10mm bolts holding it down.... And 2 more under the rear cup holder...

 

[blue99tahoe24]

Ok ill check it out thanks

 

[Tricky]

Man, Blue good find and GL if its still there tomorrow. If I didn't have to work I would be I355 bound in the am. I been looking around far South Suburbs since I got MYHOE new in 2000. And can't afford ones that are being sold since we have one income due to wife having MS. But if you don't go to yard and not going to get it let me know and I will shoot that way when I get off at 3 if no one else lucked up on it. And I was in Elk Grove earlier today in Government car.


Sent from my iPhone 4s using Tapatalk.

 

[blue99tahoe24]

I got it sorry tricky but the guy told me they have another denali they just havent put it out yet so i will keep my eyes peeled for ya bro.

 

[slipping]

I got it sorry tricky but the guy told me they have another denali they just havent put it out yet so i will keep my eyes peeled for ya bro.

Good work! Cool on the good deal!

 

[blue99tahoe24]

Had to have it what kind of paint should i use to redo it kinda beat up thanks

 

[slipping]

Depends on prefrence. I used SEM paints



Can get at local paint supply store, amazon, eBay.....paint was 17$ and adhesion promoter was like 10$ can go to website to see OEM colors.

You can get the duplicolor plastic and vinyl paint for I think its like 5 or 6 bucks. I know a lot use this but I have not so can't give details on it.

Make sure you prep it good no matter what you use. I use dawn foam dish soap to wash it all up. Again, my preference.