Travieso
Boooooooost !
has anyone put a rear Performance Cover/Girdle on the rear end? Wondering what clears the rear sway bars,????
Diff Covers?
- Thread starter Travieso
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
OP
OP
Travieso
Boooooooost !
I doubt if there's any room for a Mag-tech, those usually add a couple of quarts to the pumpkin, Last time i looked very little room, currently building the rear end and will like to know the answer so i could bite the bullet on one..
Well I'm. Gonna be in a pickle soon getting new drive shaft cut already bought a Marrow axle conversion and have to have fab shop cut and weld the Tubes, and spring perches. I am about to do a ford 9-3/4 axle swap! Don't know what the heck to do about the rear sway bar.
OP
OP
Travieso
Boooooooost !
Very nice im going with 4.30's Gears USA Standard, Detroit TrueTrac
Master install kit with timken Bearings and Rear Axle Seals, do you think i should upgrade my Axles to something stronger ?
I've also been tinkering about 1350 U joints and yokes any place you could recommended me as far as a custom drive shaft?
YuCanada
Full Access Member
I have had one sitting in the Tahoe for months now. After I stopped driving it I never got around to installing it. Nor check to see if there was room for it. Maybe I'll dig it out and have a look today.
I seriously doubt this is any room for a bigger nice one on a NNBS. The panhard is right in front of it.
YuCanada
Full Access Member
Oh are we in nnbs category? Lol damn tapatalk I never know what section I'm in when I browse the latest category.
Actually I don't know what category we are in either...... tapatalk does not show me either.
OP
OP
Travieso
Boooooooost !
we are on NBS category
