Energy Suspension Bushings

[dhulsey779]

Has anyone replaced the Front & Rear factory bushings with Energy Suspension?
After reviewing the installation instructions, it seems to be more of a POA instead of just replacing the rear Upper / Lower control arms completely. If anyone has done it, how long of a process is it?

Now I know a lot of forum members run the Spohn Performance adjustable rear components, but not sure I exactly need to go that far just to tighten up my 2/3 lowered Tahoe.

Just looking to see which way to go just to tighten up the rear suspension a bit better. Already did the sway bar bushings front & rear.

Thanks
Dave

 

[dhulsey779]

Anyone???

 

[On3honksgo]

Mine is a 98, I actually installed the energy suspension poly urethane mounts on the front sway bars today actually, it wasn't bad at all but, I have my whole front end of for replacement..... this is wat it looked like after the install....look at the gap in the bottom right corner where the circle higs the swaybar....i dont know ifbthisif this is right, or will it settle out and snug up once its on the ground wothwith weight on it.