Esky with Airaid Intake/BBP Tune: Check Engine/Stabilitrak/Traction Control Issues

[felixgun]

Well you guys were right. Took a look under the hood and the MIT popped off. It was technically still flowing air (barely) as it was all lined up, but it was fully off. As soon as the car was turned on after the MIT was securely put back on, the Traction control and Stabilitrak issues went away but the CEL is still on... thanks for the help guys.

 

[livingez_123]

I would be the CEL will go off after a few key cycles.

 

[felixgun]

Really? That would be great if it did. The ST/TC issues went away immediately. I hope you're right because I'm too lazy to plug in my EFI Live AutoCal just to reset this code.

 

[Ben]

CEL will go away.

 

[felixgun]

CEL just went away on it's own

 

[Ben]

told yaaaaaaaaaa

 

[blkonblk]

This just happend to me, if you have a airaid check and make sure the screws are tight. Mine was fine for a year now, should of checked it when I read this thread and this would of not happened. Hope the cel goes away soon

Sent from my SGH-M919 using Tapatalk

 

[felixgun]

It will. Mine went away after a few days.

 

[felixgun]

So I start the Esky up yesterday with remote start and while I'm strapping in my two year old in the car seat the car just turns off. CEL is back. ****. So I figure the airaid jr intake tube just popped off again no biggie. I pop the hood and the intake tube is on. **** again. Anyone have similar issues?

 

[blkonblk]

So I start the Esky up yesterday with remote start and while I'm strapping in my two year old in the car seat the car just turns off. CEL is back. ****. So I figure the airaid jr intake tube just popped off again no biggie. I pop the hood and the intake tube is on. **** again. Anyone have similar issues?

I disconnected the battery, it went away for a day then back on again. Not sure what to do,,, can't remote start with the cel light on

Sent from my SGH-M919 using Tapatalk