Flickering lights

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

petethepug

Michael
Joined
May 4, 2016
Posts
3,100
Reaction score
3,417
Location
SoCal
Our 08 YXL Denali did that when the a/c cycled the engine fan to high speed but only on the headlamps. I lived with it until sold it.

Still scratching my head on what it was.
 

Fless

Staff member
Super Moderator
Joined
Apr 2, 2017
Posts
12,154
Reaction score
24,773
Location
Elev 5,280
Did the voltage drop tests include body grounds as they relate to the engine block and the battery negative terminal?

And the positive from the alternator lug, and the megafuse lugs, to the battery positive terminal?
 

Doubeleive

Wes
Supporting Member
Joined
Nov 7, 2017
Posts
26,498
Reaction score
39,864
Location
Stockton, Ca.
Yes. I tried cleaning them but still flickering so replaced everything. That terminal comes with the GM replacement cable that runs to the fuse box. The new fuse looks rusted but it's not..the brass came that color from the factory. View attachment 436031
where did you source that? shouldn't be a spec of rust on a new oem one if you got that from a dealer I would be asking them wtf?
 
OP
OP
solli5pack

solli5pack

Full Access Member
Joined
Jun 17, 2023
Posts
253
Reaction score
391
where did you source that? shouldn't be a spec of rust on a new oem one if you got that from a dealer I would be asking them wtf?
It's from Rock Auto and came in a genuine GM box. It looks a lot like rust in the picture but it's not.
 

bacon612

Member
Joined
Sep 9, 2010
Posts
63
Reaction score
23
Hey OP. I just saw this thread after posting this one. Not trying to cross post but it sounds like we may have the same issue.


What I don't fully understand is how to test resistance on my grounds with my multimeter but this sounds like it might be the way forward.

I've read that g203 is a problem with these trucks and is located on the driver a pillar under the dash. A pain to get to as you have to remove the dash to get to it.
 
OP
OP
solli5pack

solli5pack

Full Access Member
Joined
Jun 17, 2023
Posts
253
Reaction score
391
I think your problem might be a little different than mine since you actually have some devices not working properly. My only issues is flickering lights. As far as checking grounds I check resistance by putting the multi meter on ohms and placing one probe of the meter on the negative battery terminal and the other probe on the ground you want to check. You should have very close to zero resistance. Also using the same procedure make sure there is close to zero voltage between the two.
 
OP
OP
solli5pack

solli5pack

Full Access Member
Joined
Jun 17, 2023
Posts
253
Reaction score
391
Did the voltage drop tests include body grounds as they relate to the engine block and the battery negative terminal?

And the positive from the alternator lug, and the megafuse lugs, to the battery positive terminal?
I've checked every combination possible and no voltage loss anywhere.
 
OP
OP
solli5pack

solli5pack

Full Access Member
Joined
Jun 17, 2023
Posts
253
Reaction score
391
It's probably the alternator. The original on my 2008 Denali started doing that on a trip from CA to WI in 2021......kind of unnerving at 1:00 a.m. But, it didn't stop working. I put a new lifetime alternator from Carquest and the flickering stopped. Been 50k miles and no issues.

But, as others have suggested, cleaning the connections is a good practice and, based on your pictures, was worthwhile.
Three different alternators. Same problem.
 
OP
OP
solli5pack

solli5pack

Full Access Member
Joined
Jun 17, 2023
Posts
253
Reaction score
391
So I checked all the grounds in the engine compartment and so far everything is testing good. I need to get to the ones behind the bumper and check those next but it's hot as hell right now in Jersey so might wait a few days. Also swapped batteries from the Suburban and the issue remains. I have all the wiring diagrams and ground locations printed from All Data and eventually I'm gonna check everything until I find this Gremlin! I'm also eyeing up the headlight switch since everything that's flickering seems to run through it. Like I said I believe this truck spent it's previous life living at the Jersey Shore so quite a bit of rust and corrosion to work through.
 

Doubeleive

Wes
Supporting Member
Joined
Nov 7, 2017
Posts
26,498
Reaction score
39,864
Location
Stockton, Ca.
So I checked all the grounds in the engine compartment and so far everything is testing good. I need to get to the ones behind the bumper and check those next but it's hot as hell right now in Jersey so might wait a few days. Also swapped batteries from the Suburban and the issue remains. I have all the wiring diagrams and ground locations printed from All Data and eventually I'm gonna check everything until I find this Gremlin! I'm also eyeing up the headlight switch since everything that's flickering seems to run through it. Like I said I believe this truck spent it's previous life living at the Jersey Shore so quite a bit of rust and corrosion to work through.
headlight switch is not a bad idea, you could try unplugging the rvc module to see if that makes any difference also. that is the clamp looking module that is on the ground cable connected to the battery, unplugging it will not cause any problem.
if all else fails you can try adding a ground to the light circuit in the past this has helped myself and others, the light circuit has been known to have a poor ground.
you might want to take a look at the fuse box too for corrosion.
 

Forum statistics

Threads
132,726
Posts
1,873,242
Members
97,556
Latest member
gy_psi
Top