For those running cut 6” Norcal coils for 7” drop

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Blittlejohn53

TYF Newbie
Joined
Apr 7, 2018
Posts
1
Reaction score
0
I’m running Tony’s 5/6 drop with helper bags and 22 reps.

I want 7 drop to match the front, going to cut half a coil out, seen a few guys on here saying there running that set up just looking for some feedback on the setup.
 

JasonLmarsh

TYF Newbie
Joined
Aug 7, 2017
Posts
16
Reaction score
6
Just curious here, How would you cut the spring and have it fit properly in the truck? The upper and lower ends of the springs are tapered down to fit the spring pocket. If you cut the spring how will it stay in place once the inner dimensions of the coil spring is 3"-4" larger than the spring perch?
 

Doug118

Full Access Member
Joined
Sep 22, 2012
Posts
536
Reaction score
1,004
Also curious as to how you'd go about that
 

1lowhoe04

Full Access Member
Joined
Nov 15, 2010
Posts
486
Reaction score
99
Location
Fort Worth Texas
The upper spring is a pocket / cup it sits into tony says you can cut his springs and the weight of the truck will allways keep them in unless you put on a lift and drop the rest end !
I have his rear springs in mine have not cut yet been debating on doing so
 
Joined
Jan 22, 2021
Posts
32
Reaction score
22
The upper spring is a pocket / cup it sits into tony says you can cut his springs and the weight of the truck will allways keep them in unless you put on a lift and drop the rest end !
I have his rear springs in mine have not cut yet been debating on doing so
Did u ever cut them and how was the ride ?
 
Top