red02chevy
Full Access Member
The way I do it I would charge atleast $200. If I wasn't lowering their Tahoe at the same time it'd probably be closer to $300. I do quite a bit more then just simply cutting the bracket off like the pictures show.
Free Travel Mod....
- Thread starter OnE_bAd_HoE
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
seriously, 30 mins?? took me the better part of a day to do both sides. but i have a burban and the drivers side runs so damn close to the tank. that and on the inside the bracket goes into the spring pocket so i couldnt even grind down the welds all the way. does ride a hell of a lot better now!
Dagreaser
TYF Newbie
Good write up and good information
felixgun
Full Access Member
I think you do this afterwards... itis in addition to the springs/drop.
OP
OP
OnE_bAd_HoE
Senior Member
I was told it is easier if you do it before you do the drop. because you get a lil more clearence.
It doesn't matter when you do it, the springs still have to come out and the rear end dropped down. Either whiling doing the drop initially or after it's been done, as I did mine, the work is the same.
Thanks, I will have to look into it and the only problem I can see is if no shops know what the free travel mod is.
OP
OP
OnE_bAd_HoE
Senior Member
i had that problem but just print these pictures out and tell them exactly how u want.
White07Tahoe
Full Access Member
Do you have to use a plasma cutter or can I do the whole job with a cutting wheel?
crazycrew
Full Access Member
I did the pass side with a sawzall and the drivers side with a plasma. Just be sure for the drivers side to put something thick enough or a piece of fire blanket between that and the tank.
Ask me how I know????!?!!?!! LOL
Ask me how I know????!?!!?!! LOL
Last edited:
