Gonna get rid of the 26's. Local NY NJ CONN PA

[08grey]

I am lowering the truck and putting on 24's. I had these 26's on for 2k miles a Little over 2 months.

Lexani lx nine 295 30 26. 25mm offset. Pilot high pressure tpms sensors. Black lock lugs with 2 keys

I paid 2579 for the set. I would much rather see a forum member get them.

They look amazing when they spin. Gets lots of looks.

One spoke was curbed by a professional douche parking attendant and professionally redone to about 85 percent at In your face up close. Can't be noticed from 3 feet. Before and after quick pics attached.

Pm if interested And we can go from there.

 

[dragthepaint]

Pm'd

 

[08grey]

Bump still for sale.

 

[Jbell25]

Good luck with sale ..to far for me...how low you going?

 

[08grey]

I went 2/3 so far I am having some clinks and clanks. Just been real busy and have not had time to get more into it. So real soon ill dedicate two or so days to it. Hard to secure lift time always something on it.

 

[Jbell25]

You should just keep them..I run a 2/4 drop on 26s....I love it man

 

[08grey]

What offset do you have?

 

[GalaxyBlackEsky]

To be honest you will be fine on that offset. My Gianelles are 23mm offset and I only rub full lock on backup with a slight incline. Plus you are on 295's.

---------- Post added at 08:13 AM ---------- Previous post was at 08:10 AM ----------

Also with the a lift you can get that done in 3-4 hours. I did my front spindles on a lift in one night. But I also did my rear springs in about 30-40mins without a lift and just floor jack and jackstands. Really easy to do the rears.

 

[08grey]

Thanks guys. I am already dropped. I have a bad shoulder Right now and need neck rx. Allot of things I did on the ground before I can't do anymore because I will feel it for a week after. I never tried the 26's back on after I dropped it. Guess I have a project for next week.

 

[Jbell25]

23mm...I rub when lock to lock with a 305...but I don't mind...going swap to 295 down the road