Hi All
Changed The blend door actuator. under the Glove Compartment Still blowing heat out
Of the passenger side. Now after reading for several hours I have found out I changed the Drivers side actuator. I guess it is OK as the drivers side acts up rarely but does act up.
Other problems noted and learned.
1 The rear unit now only blows cold. Looks like the rear AC controller mounted on the
rear Blower case is the problem. one with the Red / Gray connectors
2 The front AC control head "when it is cold out" when you set the temp from cool to
warmer the temp readout will go up one or two degrees and then down a few degrees
when it warms up works correctly most of the time.
All in all I really like the truck the manacles have been great But the Electrons SUCK lately.
The truck is coming up on 190 thousand miles other then service work it has been good.
Some of the repairs I have done
Had Coolant leak at water pump " Bad Gasket " changed gasket, thermostat, water pump
and all hoses $$$ While we were in this deep Replaced Bad "wet" Knock sensors When all
back together would not turn over. Replaced Starter. Started right up. This was all at 180k
Factory Brakes went 175K still had some pad left.
Changed Alternator 150K
Rebuilt Dash Gage Cluster 145K
Last Week end The Tailgate window Hinge came louse from the Glass Can not be re-glued
will need a new window !@@## $$$
All in all it is still cheeper then a car note. I have learned a lot from these forums but all the answers are not correct. So read read and read some more. You will get the correct answer
if you keep looking.
Also THANK You to all that try to help each other together we can fix most things
Michael