How to replace fog light housing on 2016 Yukon?

[cderoche]

Can't find anything on YouTube fitting my specific vehicle for this job.... But a while back when upgrading to LED fog lights I managed to crack the part that holds the bulb in place. I ended up using silicone to hold the bulb in place for the time being. Now that its time to replace the LED fog lights since one burnt, I also ordered the replacement housing for the driver side. Does anyone have an shortcuts or easier way to do this task? Closest video I can find is this

which is for a Silverado 1500 similar year. I'm not sure if this is what I'll be dealing with, looks like this mechanic had a difficult time with this and I'm not a mechanic nor have a lift etc like these guys.

(talking about replacing this part)

 

[cderoche]

Update, it wasn't very hard to change out the lens. 4 screws hold the frame in place that holds the lens assembly. To make life easier for me, I jacked up the vehicle, removed the drivers side tire and unscrewed about half the screws for the fender cover felt stuff, pulled that out of the way, got a good light behind me so I could actually see what I'm doing. And aside from the 4 screws holding the mount I only needed to pop out one clip holding the fog light wiring. The lens assembly pops out once you put a small socket over them to squeeze closed each of the three round white plastic clips seen in the picture, I forgot the size I used, did one at a time and pushed it through.