Lifts and clearing tires

[07z71hoe8]

I currently am running a 3.5 inch rough country on my 2007 z71 tahoe. Does anyone know how to cheaply get and extra 2 inches to make clearing 35's easier?

 

[Neil Layne]

http://www.tahoeyukonforum.com/forum/showthread.php?t=48022

---------- Post added at 09:39 PM ---------- Previous post was at 09:37 PM ----------

this guy isn't running 35's but he is running something close to it. I don't know if you're running a body lift either but this is what it'll look like essentially. Do you have a leveling kit on top of your lift or no?

 

[07z71hoe8]

http://www.tahoeyukonforum.com/forum/showthread.php?t=48022

---------- Post added at 09:39 PM ---------- Previous post was at 09:37 PM ----------

this guy isn't running 35's but he is running something close to it. I don't know if you're running a body lift either but this is what it'll look like essentially. Do you have a leveling kit on top of your lift or no?

No i dont have one. is It possible to do like just throw some coil spring spacers under the front or something like that?

 

[wbreaux]

I rock a bl and not mess with your angles any more. Idk what they look like on rc 3.5 but I wouldn't imagine its great

 

[Zed 71]

Are 2WD?

 

[RoRo]

Be prepared to do some trimming, I went with a Fabtech 6" and 35 and needed to trim the bumper cover and steps.

 

[wbreaux]

this is a nnbs tahoe on 35s and I believe it just has an rc 3.5 on it in this pic. I think he added a 2 or 3 inch bl later on

 

[07z71hoe8]

its 4wd

---------- Post added at 11:00 PM ---------- Previous post was at 10:59 PM ----------

My buddy runs the same set up. It looks good on him. i think im gonna go with a 1.5 inch body lift or either a 1' bottom spacer.

---------- Post added at 11:01 PM ---------- Previous post was at 11:00 PM ----------

not worried about trimming and my running boards and steps are off i like the clean look

 

[Zed 71]

^ IMO do not put a spacer on that lift. I would think the CV angles would be too much.

Gonzo and another member are running 35s, but they have the 4-inch Rancho lift.

 

[wbreaux]

^ IMO do not put a spacer on that lift. I would think the CV angles would be too much.

Gonzo and another member are running 35s, but they have the 4-inch Rancho lift.

This. Do not make your angles any worse than they will be with the rc 3.5