Yea i pulled out the bolt and shaved the bracket down, thank youBe sure to pull out one of the bolts in the bottom of the battery holder. It will rip your front tire up good. Looks sick
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Yea i pulled out the bolt and shaved the bracket down, thank youBe sure to pull out one of the bolts in the bottom of the battery holder. It will rip your front tire up good. Looks sick
Slammed 5 inches in front and 7 inches in the back, plus an extra 1/2" when the subwofers are in.
View attachment 444806View attachment 444808View attachment 444807
Is that your truck in your avatar pic? If so, where are full pics of it in the '21+ section?!If you get a chance, could you measure the clearance between the trailing arm and the ground? LOOKS like about 2".
I only want a 2/3 drop. Will this result in the trailing arm being higher off the ground than what you have in your setup?
Wherever you want! Start a new thread in General, or post a pic in the “black wheels” thread in Exterior, or put one in any thread about roof racks… JUST POST SOME PICS!It is!! it's the only pic I have currently. I want to get it lowered before posting pics. Weather is ****** here, so it's going to need a detail too. Where is everyone posting pics?
I don't remember the exact measurement but it was a little bit over 2". The arm will sit a little bit higher if you do not go that low but not by much.If you get a chance, could you measure the clearance between the trailing arm and the ground? LOOKS like about 2".
I only want a 2/3 drop. Will this result in the trailing arm being higher off the ground than what you have in your setup?