LT Tires and DIC message

[ChrisK7UND]

Hello All,

For winter I got BFG All Terrains and they are LT tire and are at 50psi. The DCI tells me to check the tires every time I start the truck and I have to press the cycle button 5 times to acknowledge the message. I talked to Michelin and they said to keep the tires at 50 and not lower to the 32 the Tahoe is looking for. Anybody else find a cure? They thought the dealer could adjust the range that the sensors are looking for. Anybody done this?


Sent from my iPhone using Tapatalk

 

[Jason_S]

This might not be very helpful, but my 2500 Suburban runs tire pressures in the 50's or 60's and the TPMS is looking for that. I can't tell you if it is in the sensors or in the computer, but I would guess the computer.

 

[fatboyracing]

I would assume the dealer is going to be your only option

 

[iLikeEggs]

I run 60psi I my Michelin load range E's and the sensors seem fine. Is this just a winter set or permanent? We're the sensors synched when the tires were put on? I had to got back to the tire shop a second time for them to such up the sensors again. When the tires were freshly installed I had a similar DIC message.