Davyboy
Full Access Member
Have started cleaning up the outside of the Yukon,
Rear End - Debadged (just little bit of sticky stuff still trying to get gone)
Sides - Removed the black part above the chrome (noticed that it must have been in a minor fender bender long ago, cause rust was peaking over the top, so started pealing, and bit of a mess underneath, its defiantly going to need full painting, though can't afford that at the moment, so am making do with what I've got)
I'm going to finish getting the glue off, on parts there wasn't anything holding it, and when the neighbors dog ran past me, bumped me and I lost my balance, I pulled back much harder than intended. The part with the rust didn't hold however it sure gripped the paint next to it, so there are a few paint less spots, which I'm going to sand down, and right from the little indent in the side (that runs the whole length) down, I'm going to repaint, make it look presentable.
Rear End - Debadged (just little bit of sticky stuff still trying to get gone)
Sides - Removed the black part above the chrome (noticed that it must have been in a minor fender bender long ago, cause rust was peaking over the top, so started pealing, and bit of a mess underneath, its defiantly going to need full painting, though can't afford that at the moment, so am making do with what I've got)
I'm going to finish getting the glue off, on parts there wasn't anything holding it, and when the neighbors dog ran past me, bumped me and I lost my balance, I pulled back much harder than intended. The part with the rust didn't hold however it sure gripped the paint next to it, so there are a few paint less spots, which I'm going to sand down, and right from the little indent in the side (that runs the whole length) down, I'm going to repaint, make it look presentable.
