NNBS Yukon tails in a NNBS Burb??

[07Burb]

Will tails out of a 07-10 Yukon fit in an 07-10 Burb without modification? I'm about 99% sure that the assembly will fit without an issue but I'm wondering if I need to get the wiring harness as well to make it work? I'm just looking to change up the 07 Burb a little bit and I like the Yukon tails. It's either I do that or I've got my eye on some LEDs off eBay but I wanna be different.

Anyone have experience with this swap?

 

[07Burb]

Anyone?

 

[bauer4567]

Yes. All the NNBS tails are interchangeable, except read up on the LED hyper blink issue if going from standard hal bulbs to LEDs...

 

[07Burb]

Yes. All the NNBS tails are interchangeable, except read up on the LED hyper blink issue if going from standard hal bulbs to LEDs...

So there's no need for me to get a new wiring harness if I put Yukon tails in my Burb?

 

[bauer4567]

No. The plug is the same, and it is right at the tail light. It is a fairly universal plug across GM as a whole... These two vehicles will certainly be the same...

The only thing that MIGHT change that is if you are switching TO LEDS, from NON LEDS. Even so, it could be safely assumed it is still the same connector, but you might need to add the resistor to avoid hyper blink...

 

[07Burb]

Sounds great! Thank you for the good info

 

[zach2011]

We need a thank button like some forums have for helpful members like that.

 

[07Burb]

We need a thank button like some forums have for helpful members like that.

definitely agree with that. I think we all appreciate a members willingness to help spread the knowledge and taking the time out of their day to help out with a question.

 

[felixgun]

Yes. All the NNBS tails are interchangeable, except read up on the LED hyper blink issue if going from standard hal bulbs to LEDs...

Which is not 100% constant like in my case.. Read so much about it that I bought 6 ohm resistors in preperation for the fast blink issue which NEVER occured! But yes, it does happen time to time and you MIGHT have to get some 6ohm (vs 10 ohm that comes with the led tail) resistors.