The rear AC was blowing hot air, common problem. So I purchased a new control module. Reset the system following this page advice : http://www.sparkys-answers.com/2011/08/hvac-actuator-recalibration-procedure.html
Still the same. So I buy a new blend door actuator. No fix. I noticed that the blend door is broken and the piece that fits inside the motor is nowhere to be seen through the little hole. At least i know that's why it is stuck on hot.
Here is what gets me, multiple resetting of the HVAC system with both the old and new control modules and when the rear control knobs are turned neither the position actuator or the blend door moves actuator at all? Previous to this I could adjust the floor or overhead setting but it was just hot air. Did i just get a bad replacement module?
Where can I buy a new blend door? No doing that blend door fix heater treater thing. I searched and searched and all that comes up are the actuators. Even then I need to find out why no actuators are moving.
Still the same. So I buy a new blend door actuator. No fix. I noticed that the blend door is broken and the piece that fits inside the motor is nowhere to be seen through the little hole. At least i know that's why it is stuck on hot.
Here is what gets me, multiple resetting of the HVAC system with both the old and new control modules and when the rear control knobs are turned neither the position actuator or the blend door moves actuator at all? Previous to this I could adjust the floor or overhead setting but it was just hot air. Did i just get a bad replacement module?
Where can I buy a new blend door? No doing that blend door fix heater treater thing. I searched and searched and all that comes up are the actuators. Even then I need to find out why no actuators are moving.
Last edited by a moderator: