Service stability light on again

[06xl]

Ok so after the first episode of having this issue after installing my Wilwood kit I had it check out by a mechanic and he cleared the service stability codes now this time I have the service stability message display on my DIC but no stability light comes on and brakes lock up on me while driving. I I'm so lost as to what is my next move with this issue after the 1st time it was cleared i drove 6hrs round trip no problem brakes performed flawlessly started the truck up 2 days ago and know my brakes are locking. Any advice will be great.

 

[06xl]

Anyone??

 

[Modded]

You may have snagged the ABS wire/connector while installing the brakes. Go back and check the ABS wire on all four corners for any faults, and make sure the connectors are good to go.

 

[06xl]

Wouldn't a light come on?? I will check any how

 

[chrisu7582]

Also make sure that the Service stability plug is secured. You can accidently raise your toe up and snag it and pull it out. Although it is hard to do, I have seen it done.If you dont know where it, crawl into the floor space under the steering wheel. Look up above the brake pedal and find where the steering column goes into the engine compartment. There will be a plug that is attached the the bottom of the steering column and that is it.

 

[06xl]

I will check that out ASAP I have a backup siren under there that has a key to turn off when alarmed so I might have touched the plug on accident