Service Traction Control and Stabilitrack?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

NASTY GM

Full Access Member
Joined
Jun 15, 2009
Posts
766
Reaction score
284
Location
Nor Cal
I rotated my tires and changed my rear shocks (to Belltech). Now I have Service Traction Control and Service Stabilitrack message. Also my ABS light is lit on my dash. I have rotated my tires and changed rear shocks before and this never happened. Any ideas?
 

3blackchevys

Full Access Member
Joined
Apr 30, 2009
Posts
863
Reaction score
1
Location
New Jersey
not Tahoe/Yukon related, but I had the same problem in regards to the service stabilitrack message on my trailblazer. turns out it was a steering wheel position sensor
 
Last edited:

Modded

That Guy
Joined
May 3, 2009
Posts
6,942
Reaction score
108
Dude you may have snagged the rear ABS sensors that coneect to the frame then wheel area, it tends to happen alot when people install lowering kits because they are careless when dropping the axle.
Are you sure you didn't snag them?
Also I had those codes pop up on me but they went away after like 15 minutes and the dealer said the car had just accidentally thrown a wrong code!
 
OP
OP
NASTY GM

NASTY GM

Full Access Member
Joined
Jun 15, 2009
Posts
766
Reaction score
284
Location
Nor Cal
I got it. I went back under and found both plugs on top of the frame rail came undone. Plugged both back in and all is good!
Thanks Fellas
 

Forum statistics

Threads
133,292
Posts
1,882,991
Members
98,353
Latest member
fastpete
Top